Table of Contents
Advertisement
REAR PANEL
21
18
23
22 22
19
15. MIC/LINE INPUTS 3 to 8 – Combo XLR input sockets - connect further microphones or line
level signals via XLR or ¼" jacks as appropriate. Either ¼" TRS (balanced) or TS (unbalanced)
jack plugs can be used for line level signals.
16. INSERTS 1 & 2 – two ¼" TRS jack sockets, providing an access point for connecting external
processing equipment into Channels 1 and 2. The inserts are enabled by the front panel
INSERT/AIR switches [6] and [8], and are unbalanced. The sockets are wired as follows:
Note that the front panel O/L LED [5] monitors signal level pre the insert send so excessive
signal level is not sent to external equipment.
17. INSERTS 3 to 8 – 6 x ¼" TRS jack sockets providing the insert points for Channels 3 to 8; these
are electrically identical to [16].
18. OPTICAL OUT – two TOSLINK connectors providing the digital outputs of the unit. Use of the
two connectors is sample rate-dependent, as follows:
Sample Rate
44.1/48 kHz
88.2/96 kHz
176.4/192 kHz
19. OPTICAL IN – two TOSLINK connectors providing the digital inputs to the unit when used
in the ADAT>LINE mode. Note that these are NOT "digital" inputs to Channels 1 to 8, and
signals applied at these ports do not pass through the AIR circuitry, nor are available at the
inserts. Use of the two connectors is sample rate dependent, as [18].
6
20
Jack contacts
Tip
Ring
Sleeve
OUTPUT 1 (RH port)
Channels 1 to 8
Channels 1 to 4
Channels 1 and 2
15
17
Function
Send (output)
Return (input)
Ground
OUTPUT 2 (LH port)
Channels 1 to 8
Channels 5 to 8
Channels 3 and 4
16
16
Advertisement
Table of Contents
