Table of Contents
Advertisement
Do not make any adjustments whilst the saw blade is
in motion.
Always make sure the battery pack has been removed
from the product before making adjustments, lubricating
or when doing any maintenance on the product.
Before and after each use, check the product for
damage or broken parts. Keep the product in top
working condition by immediately replacing parts with
spares approved by the manufacturer.
The blade has sharp edges and may also remain hot
yourself from personal injury.
Clean the saw and its accessories from dust regularly,
especially moving parts including the blade guard.
Use a hand brush or vacuum cleaner to remove dust
effectively. Do not use compressed air.
For greater safety and reliability, all repairs, including
changing brushes, should be performed by an authorised
service centre.
WARNING! Do not attempt to disassemble the blade
guard assembly for cleaning or repair. Damaged guards
should not be used. Return to an authorised service centre
for repair or replacement.
Mitre and bevel angle calibration
If mitre and bevel angle calibration are needed, see pages
TRANSPORTATION AND STORAGE
When storing the product, remove the battery pack.
Store the product in a secure place that is not accessible
to children.
Clean the product using a brush and vacuum cleaner
before storage.
If you remove the saw blade or keep spares with the
unit, ensure they are in the original packaging to prevent
injury.
To secure the product prior to movement:
The product should be stored at the zero degree mitre
and bevel angle and locked in position. The handle
should be locked in the lower (safe) position with the
guards closed.
To move or transport in a vehicle:
Secure the product prior to movement as described in
the manual.
Remove the product from the bench top by releasing the
4 bolts, one at each corner. Secure the bolts for future
use. When lifting to a height, two persons wearing heavy
gloves are needed to lift the base of the product.
When transporting in a vehicle, set the product on its
base and secure against movement.
SYMBOLS ON THE PRODUCT
Safety alert
European Conformity Mark
8
Original Instructions
British Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
Please read the instructions carefully
before starting the machine.
Wear ear protection
Always wear eye protection.
Keep hands away from the cutting area
and sharp blade.
locations.
Wear safety gloves
Blade rotation direction (shown on saw
blade)
Blade rotation direction (shown on
blade guard)
Blade width of cut (Kerf)
Number of teeth on this saw blade
Cutting capacity
For cutting wood and analogous
material
Not for cutting metals
Adjust the position of sliding fence
before performing bevel or compound
cuts.
Loosening direction of blade bolt
Waste electrical products should not
be disposed of with household waste.
Check with your Local Authority or
retailer for recycling advice.
Advertisement
Table of Contents
