Subscribe to Our Youtube Channel
Related Manuals for Satel Proof-TR4+
Summary of Contents for Satel Proof-TR4+
- Page 1 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 SATEL Proof-TR4+ SATEL Proof-TR9 SATEL Proof-R4+ Radio Modem User Guide...
-
Page 2: Table Of Contents
User Guide, Version 2.2 TABLE OF CONTENTS TABLE OF CONTENTS ..................2 IMPORTANT NOTICE ..................4 RESTRICTIONS ON USE – SATEL PROOF-TR4+ ..........5 RESTRICTIONS ON USE – SATEL PROOF-TR9 ............ 6 PRODUCT CONFORMITY ..................8 WARRANTY AND SAFETY INSTRUCTIONS ............9 1 DESCRIPTION OF THE PRODUCT .............. - Page 3 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 Transmitter ................... 24 Receiver ....................25 Encryption ..................... 25 Radio state ................... 26 Priority RX/TX ..................27 Forward Error Correction (FEC) ............27 Error checking ..................27 TX delay....................28 Add RSSI to data .................. 28 8.10...
-
Page 4: Important Notice
User Guide, Version 2.2 IMPORTANT NOTICE All rights to this manual are owned solely by SATEL Oy (referred to in this user guide as SATEL). All rights reserved. The copying of this manual (without the written permission from the owner) -
Page 5: Restrictions On Use - Satel Proof-Tr4
SATEL Proof-TR4+/R4+ are allowed to be used in the following countries, either on license free channels or on channels where the operation requires a license. More detailed information is available at the local frequency management authority. -
Page 6: Restrictions On Use - Satel Proof-Tr9
SATEL Proof-TR9 is allowed to be used in the following countries. More detailed information is available at the local frequency management authority. Countries: AU, BR, CA, US The frequency band in USA and Canada is 902 –... - Page 7 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1.
-
Page 8: Product Conformity
User Guide, Version 2.2 PRODUCT CONFORMITY Hereby, SATEL Oy declares that SATEL Proof-TR4+ and SATEL Proof-R4+ radio modems are in compliance with the essential requirements (radio performance, electromagnetic compatibility and electrical safety) and other relevant provisions of Directive 2014/53/EU. Therefore, the... -
Page 9: Warranty And Safety Instructions
-The radio modem is only to be operated at frequencies allocated by local authorities, and without exceeding the given maximum allowed output power ratings. SATEL and its distributors are not responsible, if any products manufactured by it are used in unlawful ways. -
Page 10: Description Of The Product
SATEL Proof-R4+ is the receive-only variant of SATEL Proof-TR4+. SATEL Proof-TR9 is a UHF (902…928 MHz license free ISM band) radio transceiver modem that provides a transparent data link with many SATEL serial radios and with many other manufacturers’... -
Page 11: Satel Proof-Tr4+/R4+ Technical Specifications
• EN 300 113 • EN 301 489 • IEC 62368-1 (safety) • FCC CFR47 Part 90 • FCC CFR47 Part 15 SATEL Proof-TR4+/R4+ TECHNICAL SPECIFICATIONS Values are subject to change without a notice RECEIVER TRANSMITTER Parameter Notes (SATEL Proof-TR4+/R4+) - Page 12 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 -33 dBm @ 25 kHz SATEL-4FSK (FEC ON) -36 dBm @ 12.5 kHz Adjacent Channel -34 dBm @ 25 kHz SATEL-8FSK (FEC ON) Selectivity -34 dBm @ 12.5 kHz -43 dBm @ 25 kHz SATEL-16FSK (FEC ON) -40 dBm @ 12.5 kHz...
- Page 13 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 IP rating IP67/IP69K See Note 1 below ESD-failure threshold 8 kV contact, 15 kV air discharge Immunity >10 V/m Vibration >20 G (20 Hz…2 kHz sinusoidal/random) Note 1: IP67/IP69K rating of the device requires the mating connector to be correctly assembled and connected into the device’s Deutsch connector.
-
Page 14: Satel Proof-Tr9 Technical Specifications
• FCC CFR47Part 15 • EN 301 489-1, EN 301 489-5 • IEC 62368-1 (safety) • IC RSS-247, ICC RSS-Gen SATEL Proof-TR9 TECHNICAL SPECIFICATIONS Values are subject to change without a notice Frequency Range 902-928 MHz Spreading Method Frequency Hopping... -
Page 15: Configuration
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 CONFIGURATION The configuration of SATEL Proof radio modem can be modified via the serial interface by using SATEL Configuration Manager software or specific SL commands. 4.1 Configuration Manager software This easy-to-use software for Windows provides access to the user settings, including the channel list editor for creating the channel lists, and the functions for restoring the factory setup and making firmware updates. -
Page 16: Commands
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 4.2 SL commands A terminal device can command or configure the radio modem via the serial data interface by using SL commands (similar to AT commands in traditional wired modems) that are applicable especially in cases where radio modems are to be integrated seamlessly inside a system behind the integrator’s own user interface. - Page 17 ("OK" or "ERROR") of the proceeding command. In addition, it is recommended to implement a timeout to the terminal software for recovering the case when no response is received from the radio modem. SL commands are described in separate documentation, contact SATEL for more information.
-
Page 18: Modem Settings
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 MODEM SETTINGS 5.1 Default settings of SATEL Proof-TR4+ The radio modem is delivered with the configuration below unless otherwise ordered. DEFAULT VALUES OF THE ADJUSTABLE SETTINGS ( the user can change these settings later) - Page 19 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 Handshaking Handshaking lines apply to the DATA-port. Pause length 3 bytes 3….255 Additional setup Error correction, FEC ON/OFF Error check OFF, CRC8Partial, CRC8Full, CRC16Full Repeater Mode ON/OFF SL-commands ON/OFF TX Delay 0 …. 65535 ms...
-
Page 20: Default Settings Of Satel Proof-Tr9
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 5.2 Default settings of SATEL Proof-TR9 The radio modem is delivered with the configuration below unless otherwise ordered. DEFAULT VALUES OF THE ADJUSTABLE SETTINGS (the user can change these settings later) Operation Mode Default value... -
Page 21: Connectors
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 CONNECTORS 6.1 Antenna connector All models have a single TNC female type antenna connector with impedance of 50 Ohm. The antenna should always be connected when the power is on. 6.2 Power/Data connector Pin-out of Deutsch DT04-6P-CL09 power/data connector... -
Page 22: Serial Port
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 SERIAL PORT The radio modem is referred to as DCE (Data Communication Equipment) whereas the device connected to it, typically a PLC or a PC, is referred to as DTE (Data Terminal Equipment). In order to transfer data, the physical interface between DCE and DTE must be compatible and properly configured. -
Page 23: Data Buffering
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 7.2 Data buffering Whenever the radio modem is in Data Transfer Mode it monitors both the radio channel and the serial interface. When the terminal device starts data transmission the radio modem switches to transmission mode. -
Page 24: Rf Interface
User Guide, Version 2.2 RF INTERFACE NOTE! This chapter refers to product using 400 MHz frequency band, please contact SATEL for more details concerning 900 MHz frequency band. All SATEL Proof radio modems have a female TNC antenna connector (50 Ohm impedance). -
Page 25: Receiver
The setting and/or using of non-approved power levels may lead to prosecution. SATEL and its distributors are not responsible for any illegal use of its radio equipment, and are not responsible in any way of any claims or penalties arising from the operation of its radio equipment in ways contradictory to local regulations and/or requirements and/or laws. -
Page 26: Radio State
It is not possible to update/change the models NOT supporting the encryption to support this feature in the field. This task can be executed is SATEL factory premises and will be charged according to the service price list. The factory default value for the encryption feature is OFF state. -
Page 27: Priority Rx/Tx
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 8.5 Priority RX/TX Priority setting selects the priority between reception and transmission. The setting can be changed in Programming Mode. By default, transmission has higher priority than reception i.e. the default value is Priority TX. -
Page 28: Tx Delay
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 CRC8 Partial verifies the data in small blocks and they are delivered to DTE as sub messages after validating. Once an error is detected, the rest of the message is ignored. In practice, if the error appears in the middle of the message, the first part is forwarded to DTE and the data in erroneous sub-message and after that will be lost. -
Page 29: Call Sign
Default value: Call sign mode OFF 8.12 Channel list NOTE! Available only in SATEL Proof-TR4+ model. A list of predefined radio channels can be stored in the memory in order to change the radio settings simply by switching between the channels. -
Page 30: Repeater Mode
Please contact SATEL for more information of Repeater- and Addressing –features. -
Page 31: Radio Compatibility Modes
This chapter applies to SATEL Proof-TR4+/R4+ only (not SATEL Proof-TR9). SATEL Proof-TR4+/R4+ provide the following radio compatibility options: • SATEL 3AS (option 0) original SATEL 4FSK data transfer mode (default) • SATEL-8FSK-1 (option 20) 8-FSK/FEC OFF • SATEL-8FSK-2 (option 21) 8-FSK/FEC ON •... - Page 32 Remote Address of a Pacific Crest transmitter (or if the message has the broadcast address 255). SATELLINE modems must have the following key settings: • FEC OFF (because the FEC here means SATEL 3AS FEC, not Pacific Crest/TRIMTALK FEC) • Error check OFF • Error Check mode OFF •...
- Page 33 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 The table below shows the analogy of settings between Pacific Crest and SATELLINE radio modems. Pacific Crest setting Corresponding SATELLINE setting Identification: Owner not implemented Identification: Channel Bandwidth Channel spacing Identification: RF Power TX power...
- Page 34 Repeater OFF/ON in the Radio Settings –tab in the Configuration Manager SW. Note 1. If error correction is ON (FEC ON) and TRIMTALK mode is activated by using ”SL@S=3” command, the firmware automatically switches SATEL FEC OFF temporarily, and turns it back at the mode return.
-
Page 35: Mechanical Dimensions
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 MECHANICAL DIMENSIONS The device dimensions in millimetres. -
Page 36: Installation
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 INSTALLATION SATEL Proof radio can be installed to any position from its 4 screw attachment points with maximum of M5 bolts/screws. SATEL Proof is waterproof fulfilling IP67 and IP69K specifications. Note that the antenna must be installed properly and Deutsch DT connector cable counterpart must have a gasket installed to properly seal the connection in order to reach the IP ratings. -
Page 37: Grounding
User Guide, Version 2.2 GROUNDING SATEL Proof radio modems are equipped with a grounding terminal, as shown below. It is recommended to connect a ground wire from the grounding terminal to the earth ground and that all other interconnected devices share the same electrical ground potential. -
Page 38: Accessories
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 ACCESSORIES SATEL provides a wide selection of accessories and solutions for its radio modems. • Antennas • Serial data/Power cables and adapters • RF-cables • Filters and lightning protectors • Power supplies • Enclosures Please visit www.satel.com... -
Page 39: Proposals For More Reliable Radio Link
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 PROPOSALS FOR MORE RELIABLE RADIO LINK In case where the environment is challenging the following methods can be used for improving the transmission reliability: • Forward Error Correction, FEC, is recommended in challenging environment like urban areas. -
Page 40: Appendix A - Transmission Delays
SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 APPENDIX A – TRANSMISSION DELAYS The tables on the next page present the transmission delays vs. the size of the message to be transmitted. The values are in 10% margin. The delays are measured from the end of transmission to the end of reception on the serial interface as shown below. - Page 41 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 SATELLINE-3AS mode (FEC ON) on 25 kHz channel - Transfer delays 1 byte 10 bytes 100 bytes 500 bytes 1200 35 ms 34 ms 29 ms 30 ms 4800 28 ms 28ms 27 ms...
- Page 42 SATEL Proof-TR4+/R4+/TR9 User Guide, Version 2.2 Pacific Crest GMSK mode on 12.5 kHz channel - Transfer delays 1 byte 10 bytes 100 bytes 500 bytes 9600 93 ms 101 ms 445 ms 2011 ms 19200 91 ms 97 ms 393 ms...
Need help?
Do you have a question about the Proof-TR4+ and is the answer not in the manual?
Questions and answers