Related Manuals for Satel SATELLINE-3AS/TC
Summary of Contents for Satel SATELLINE-3AS/TC
-
Page 1: Important Notice
User Guide Version 1.0 SATELLINE-3AS/TC Radio Data Modem Module as an Annex to SATELLINE-3AS User Guide version 2.5... -
Page 2: Restrictions On Use
SATELLINE-3AS/TC is allowed to be used in the following countries, either on licence free channels or on channels where the operation requires a licence. More detailed information is available at the local frequency management authority. -
Page 3: Product Conformity
02.12.2004 (v.1.0) PRODUCT CONFORMITY SATELLINE-3AS/TC Hereby, SATEL Oy declares that SATELLINE-3AS/TC radio modem is in compliance with the applicable essential requirements (Article 3.2) and other relevant provisions of Directive 1999/5/EC.* Therefore the equipment is labelled with the following CE-marking. The notification sign informs user that the operating frequency range of the device is not harmonised throughout the market area, and the local spectrum authority should be contacted in prior of use. -
Page 4: Table Of Contents
Header connector..................10 RF INTERFACE .................... 11 Antenna connector ................... 11 Page 4 of 11 SATEL Oy, P.O.Box 142, FIN-24101 Salo, Finland Street: Meriniitynkatu 17, FIN-24100 Salo, Finland Tel: +358 2 777 7800, Fax: +358 2 777 7810, E-mail: info@satel.fi... -
Page 5: Introduction
– the radio communication and the user interface are similar. The main differences to SATELLINE-3AS are: 1. SATELLINE-3AS/TC is delivered without the housing – only the two PCBs (the logic board and the RF board shielded as a one card) are supplied by SATEL 2. -
Page 6: Technical Specifications
Vibration Not specifed Antenna Connector MMCX, 50 Ω, female Housing SATELLINE-3AS/TC is delivered without the housing. The component blocks on the PCB are covered by metal shields Size H x W x D 13 x 100 x 123.5 mm Weight... -
Page 7: User Interface
02.12.2004 (v.1.0) 3 USER INTERFACE The user interface of SATELLINE-3AS/TC is basically similar to the standard SATELLINE-3AS radio modem – the data handling, configuration or the control of the device. The user guide of SATELLINE-3AS raio modem provides the detailed functional description of SATELLINE-3AS/TC. -
Page 8: Sl Commands
ANNEX to SATELLINE-3AS User Guide SATELLINE-3AS/TC 02.12.2004 (v.1.0) 3.2 SL commands SATELLINE-3AS/TC accepts the same SL commands as SATELLINE-3AS. The table below lists all commands available. 3.2.1 SATELLINE-3AS – SL COMMANDS LIST Frequency related Effect and description of command SL&F=nnn.nnnnn Set frequency to nnn.nnnnn MHz... -
Page 9: Free Channel Scanning Feature (Fcs)
A separate document describes the operation of the Free Channel Scan feature in details. Page 9 of 11 SATEL Oy, P.O.Box 142, FIN-24101 Salo, Finland Street: Meriniitynkatu 17, FIN-24100 Salo, Finland Tel: +358 2 777 7800, Fax: +358 2 777 7810, E-mail: info@satel.fi... -
Page 10: Header Interface
Clear To Send. This signal indicates that radiomodem is ready to receive data FROM terminal unit. Outside view of the header connector. Page 10 of 11 SATEL Oy, P.O.Box 142, FIN-24101 Salo, Finland Street: Meriniitynkatu 17, FIN-24100 Salo, Finland Tel: +358 2 777 7800, Fax: +358 2 777 7810, E-mail: info@satel.fi... -
Page 11: Rf Interface
The antenna connector is a coaxial 50 ohm MMCX receptable, and it is located on the opposite side of the module than the header connector. Page 11 of 11 SATEL Oy, P.O.Box 142, FIN-24101 Salo, Finland Street: Meriniitynkatu 17, FIN-24100 Salo, Finland Tel: +358 2 777 7800, Fax: +358 2 777 7810, E-mail: info@satel.fi...
Need help?
Do you have a question about the SATELLINE-3AS/TC and is the answer not in the manual?
Questions and answers