Kaco 87.0-165 TL3 Manual page 74

4.5 Connecting the DC cable in the device
↻ DC cable is ready in the connection area.
1 Position cable lug on DC- and DC+ wires according to the labelling on the bus-
bars and secure with screw, nut and washer. (Fastening elements included with
the device). [ _W17 /
2 Check that the connected cables are fitted securely.
3 Close the connection area of the device. [See operating instructions for the de-
vices]
» DC breaker is ready to use.
4.6 Sealing the connection area
↻ DC cable (& interface cable) are correctly installed.
1 Fit the cover with lever onto the housing and tighten using the 4 screws [
T_25 / 4-5 Nm]
2 Set the DC switch to the "ON" position.
» Inverter is connected to the PV generator. Connect in the mains voltage.
Page 74
30 Nm]
1
2
3
4
Fig. 6: DC connection to inverter
1 Stock nut
2 Lock washer
3 Fastening screw
4 DC cables
3
2
1
Fig. 7: Fit the cover
1 Cover with lever
2 Fastening screws
3 Housing
DC-Breaker