Additional Help - Overland Storage SnapServer DX2 Quick Start Manual

Rail kit change

Table of Contents

Addendum

b. Align the bar nut top hole with the screw and loosely secure the slide rail to the

rack.

c. Repeat

5. At the rear, use a bar nut and two screws in the top and bottom rail flange holes to

loosely secure the rear of the slide rail to the rack.

6. For the other rail, repeat

7. Verify both rails are level and tighten all screws.

Continue with "Install the Unit" in the SnapServer DX2 Quick Start Guide.

Additional Help

For help with your SnapServer DX2 appliance, search at:

http://support.overlandstorage.com/kb

You can email our technical support staff at

or get additional technical support information on the

http://docs.overlandstorage.com/support

For a complete list of support times depending on the type of coverage, visit our website at:

http://docs.overlandstorage.com/care

10400379-001

Steps a–b

for the fourth hole in the rack.

Steps

2–5.

techsupport@overlandstorage.com

web page:

03/2012

Table of Contents

Do you have a question about the SnapServer DX2 and is the answer not in the manual?