Related Manuals for uAvionix tailBeaconX STC
Summary of Contents for uAvionix tailBeaconX STC
- Page 1 tailBeaconX Instructions for Continued Airworthiness and Maintenance Manual UAV-1003600-001 Page 1 of 17 Rev B...
- Page 2 retained.
-
Page 3: Revision History
1 Revision History Revision Date Comments 10/04/2021 Initial release 2/3/2022 Updated based on October 2021 FAA feedback. Add info on ground testing. UAV-1003600-001 Page 3 of 17 Rev B... -
Page 4: Warnings / Disclaimers
2 Warnings / Disclaimers All device operational procedures must be learned on the ground. uAvionix is not liable for damages arising from the use or misuse of this product. This equipment is classified by the United States Department of Commerce's Bureau of Industry and Security (BIS) as Export Control Classification Number (ECCN) 7A994. -
Page 5: Limited Warranty
For the duration of the warranty period, uAvionix, at its sole option, will repair or replace any product which fails in normal use. Such repairs or replacement will be made at no charge to the customer for parts or labor, provided that the customer shall be responsible for any transportation cost. -
Page 6: Table Of Contents
4 Table of Contents Revision History ................... 3 Warnings / Disclaimers ................ 4 Limited Warranty .................. 5 Introduction ..................7 Publications .................. 7 Revision and Distribution .............. 7 Acronyms and Abbreviations ............8 System Description ................9 Features and Installation ............... 9 Interfaces .................. -
Page 7: Introduction
When this document is revised, every page will be revised to indicate current revision level. Owner/operators may obtain the latest revision of this document at www.uavionix.com or by contacting a uAvionix dealer. They may also register for updates and support at www.uavionix.com. UAV-1003600-001 Page 7 of 17... -
Page 8: Acronyms And Abbreviations
5.3 Acronyms and Abbreviations The following acronyms may be used in this document: ADS-B Automatic Dependent Surveillance Broadcast Approved Model List Air Traffic Control ATCRBS Air Traffic Control Radar Beacon System Code of Federal Regulations Federal Communications Commission Federal Aviation Administration Global Positioning System Instructions for Continued Airworthiness ICAO... -
Page 9: System Description
This device transmits Mode A, Mode C, Mode S and Automatic Dependent Surveillance-Broadcast (ADS-B) data through the 1090 MHz Extended Squitter data link. tailBeaconX replaces an existing rear (white) position light. It must be installed as shown in the tailBeaconX STC Installation Manual. UAV-1003600-001 Page 9 of 17 Rev B... -
Page 10: Interfaces
6.2 Interfaces 7 Control and Operation tailBeaconX requires serial connection to an AV-30-C control head or equivalent equipment. tailBeaconX receives transponder control and pressure altitude information from the control head. Status and annunciation information is provided by tailBeaconX to the control head. UAV-1003600-001 Page 10 of 17 Rev B... -
Page 11: Instructions For Continued Airworthiness
• Ground power source (capable of supplying sufficient power to the aircraft systems and avionics) • iOS or Android Mobile Device with “uAvionix skyBeacon Installer” • Dark glasses for viewing LEDs directly at close range • Transponder ramp test set... -
Page 12: Maintenance Intervals
8.3 Maintenance Intervals Periodic checks of the tailBeaconX system installed by the STC referenced in Section 5 are specified in Table 8-1 at specific intervals. Table 8-1 Maintenance Intervals Item Description/Procedure Section No. Interval Equipment Removal and On Condition Removal and installation of the tailBeaconX Replacement... -
Page 13: Visual Inspection
Testing – The tailBeaconX 24 Calendar Transponder requires ATC Months transponder testing and inspection to comply with CFR Part 91.413. See Note 1. Control Head The control head AV-30-C 24 Calendar Altitude pressure altitude Instructions Months Encoder reporting system must for Continued be inspected and found Airworthiness... -
Page 14: Position Light Visual Inspection
o Verify unit support structure is in good condition and its integrity is not compromised. o Inspect for corrosion and treat as required. • Inspect the condition of the wiring. o Verify that all wiring and cables are securely fastened. o Verify that the harness shows no signs of cracking, chafing, abrasion, melting, or any other form of damage. -
Page 15: Troubleshooting
10 Troubleshooting This section provides troubleshooting information to assist if problems occur after maintenance activities. Table 10-1 Troubleshooting Actions Problem / Indication Cause Action • Device not receiving power • Ensure circuit Unable to see Beacon- • Device in ALT Mode XXXX Wi-Fi network breaker is closed, navigation light... -
Page 16: Return To Service Procedure
• Any other applicable information related to the maintenance work performed on the aircraft. Appendix A includes an installation record that should be completed and updated as appropriate with every maintenance action. 12 Support For additional questions or support please visit: http://www.uavionix.com/support/ UAV-1003600-001 Page 16 of 17 Rev B... -
Page 17: Appendix A - Installation Record
A copy of this appendix must be used to record installation information and must be kept in the aircraft permanent records. A copy of this form must be submitted by visiting: https://uavionix.com/logbook/ tailBeaconX Installation and Configuration Log Date: Aircraft Information...