Advertisement
4. Procedure for Connecting the User System
Before using the LQFP-100P header type5, mount the supplied NQPACK on the user system.
The header board is used combining the emulator. Moreover, connection of a header board and
an adapter board is two flat cables (a standard or Long)appended to the emulator main part. Please
use it.
Refer to the hardware manuals of the emulator or the adapter board about the way to connect.
Connecting
1. To connect the header board to the user system, match the index mark ( ) on the NQPACK-
2. Insert each screw for securing header board in each of the four drilled holes on the header
4
mounted on the user system with the index mark ( ) on the header board and then insert it (See
Figure 3) . The pin of YQPACK is thin and easy to bent. Insert NQPACK after confirm that the
pin of YQPACK is not bent.
board(See Figure 4).
To tighten the screws, use the special screwdriver supplied with the NQPACK to finally tighten
the four screws in sequence. Please tighten a screw to a diagonal by equal power using a special
screwdriver. Tightening the screws too tight might result in a defective contact.
NQPACK Index ( )
Flat cable connector A
Flat cable connector B
YQPACK
(It mounts in the back)
Header board Index ( )
Figure 3 Index Position
Advertisement
