Advertisement
PREFACE
Thank you for purchasing the LQFP-100P header type5 (MB2198-129) for the DSU-FR emulator.
The LQFP-100P header type5 is used to connect the DSU-FR emulator (MB2198-01
DSU-FR emulator PGA-401P adapter type2 (MB2198-130
*1
family micro controller MB91270 series (LQFP-100P
This manual explains the handling of the LQFP-100P header type5 for the DSU-FR emulator. Before
using the MB2198-129, be sure to read this manual.
Consult the Sales Department or the Support Department of adapter Fujitsu Limited for mass-pro-
duction MCUs and evaluation MCUs.
*1 : FR is the abbreviation used for FUJITSU RISC CONTROLLER.
*2 : The lead pitch of PACKAGE (FPT-100P-M05) is 0.5 mm and the body size is 14 mm × 14 mm.
*3 : referred to as "emulator"
*4 : referred to as "adapter board"
Handling and use
The handling and use of this product and notes regarding safety are included in the hardware manual
of the DSU-FR emulator.
Follow the instructions in for the use of this product.
Caution of the products described in this document
The following precautions apply to the product described in this manual.
CAUTION
Cuts
Damage
Damage
• DSU-FR EMULATOR MB2198-01 HARDWARE MANUAL
• DSU-FR EMULATOR PGA-401P ADAPTER TYPE2 MB2198-130 OPERATION MANU-
AL
The wrong use of a device will give an injury and may cause malfunction on cus-
tomers system.
This product has parts with sharp points that are exposed.
Do not touch edge of the product with your bare hands.
There is a possibility that it may be injured.
When connect the header board to the user system, correctly position the index
mark ( ) on the NQPACK mounted on the user system with the index mark ( )
on the header board, otherwise the emulator system and user system might be
damaged.
When mounting a mass production MCU, correctly position pin 1, otherwise the
mass production MCU and user system might be damaged.
*4
) to a user system. That uses Fujitsu FR
*2
).
*3
) and the
Advertisement
