Felton TATE Installation Manual page 9

3
Using the Data Cable, thread the end with the small connector through the hole and Control
Mounting Tube. This end of the cable is protected with a plastic sleeve, leave this on until later
in the installation.
4
Push the Control Mounting
Tube into the hole until the
front flange sits against the
wall.
Control Mounting Tube
Foam Seal
Control Housing
CLICK
Apply a silicone bead on the
back of the Control Housing,
then push the Control Housing
into the Plastic Tube until it is
firmly fitted on the unit.
TATE DIGITAL WALL MOUNTED MIXER INSTALLATION GUIDE
Data Cable
9