Resetting The Tv To Factory Condition; Resetting The Tv To Factory Condition Using Service Mode - Sony KDL-32EX729 Service Training Manual

3. Press JUMP or
until the VPC menu displays.
VPC
000
000
4. Press 2 to move to "006 WB" Category.
VPC
006
000
5. To change the data value of the R_DRV, press
increase the value or
NOTE: The data value must be set between the range
1 to 255.
to move to the next item (001 G_DRV).
6. Press 1
7. To change the data value, press
value or 6 to decrease the value.
8. Repeat steps 6 and 7 for each of the following items:
002 B_DRV
003 R_BKG
004 G_BKG
005 B_BKG
9. To save the changes, press
10. To exit service mode, press
power off.
KDL-32EX729/40EX729/46EX729
SECTION 7 - SERVICE ADJUSTMENTS
OPTIONS on the Remote Commander
SERVICE
DATA_COPY
BU_TRANS 0
SERVICE
WB
R_DRV 128
6 to decrease the value.
3 to increase the
MUTING then press
HOME
or turn the TV
RESETTING THE TV TO FACTORY
CONDITION
Use the following instructions to restore the User Adjustments and
Channel Memory settings to the preset factory conditions.
1. While holding down the
press the POWER button on the TV Switch Unit of the
set.
2. The set restarts and displays the Initial Setup screen.
This may take several minutes.

RESETTING THE TV TO FACTORY CONDITION

USING SERVICE MODE
3 to
1. TV must be in standby Mode. (POWER off).
2. Press the following buttons on the Remote Commander
within a second of each other:
DISPLAY
3. If necessary, press
mode.
4. Press
"SERVICE" changes to green RST.
5. Press
RST executes the command and displays EXE.
0 .
on the Remote Commander,
Channel 5 Volume +
JUMP or OPTIONS
.
8
MUTING .
POWER .
to go to DIGITAL
60