Discharge Lamp Warning - ADJ HYDRO BEAM X12 User Instructions

DISCHARGE LAMP WARNING

LAMP REPLACEMENT WARNING
NOTE: The lamp life is represented in "Percentages".
When the unit reaches15% of lamp life left, the display will flash the message, "Replace The
Lamp Soon". This message will flash for up to 10 minutes. To confirm this warning and return
to normal operation, press the ENTER button.
When the unit reaches10% of lamp life left, the display will again flash the message, "Replace
The Lamp Soon". This message will flash for up to 10 minutes. To confirm this warning and
return to normal operation, press the ENTER button.
NOTE: When the fixture is powered OFF and then back ON again, the fixture display will
flash the following message: "Replace The Lamp Soon".
When the unit reaches between 5%-0% of lamp life left, the display will flash the message
"Replace The Lamp Immediately". The unit will now NO longer respond to DMX commands
and enter hibernation mode which will discontinue all fixture functionality with the exception
of a few menu commands. The fixture will continue to enter into hibernation mode until the
lamp is replaced and the lamp time (LAMP ON TIME-R) has been reset. See page 36 "LAMP
ON TIME-R" under the "TOTAL LAMP TIME" submenu.
NOTE: After replacing the lamp, the lamp time MUST be reset. The lamp time must be
reset to gain access to the full system menu.
Lamp Life may vary depending on several factors including but not limited
to: Environmental Conditions, Power/Voltage, Usage Patterns (On-Off
Cycling), Control, and Dimming.
This fixture is fitted with a DISCHARGE LAMP, which is highly
susceptible to damage if improperly handled. NEVER touch the
lamp with your bare hands as the oil from your hands will shorten
the life of the lamp. Also, NEVER move the fixture until the lamp has
had ample time to cool. Lamps are NOT covered under warranty
conditions. Avoid switching the fixture ON and OFF repeatedly in
short intervals as this will reduce lamp life and intensity. To achieve
the intensity associated with discharge lamps, these lamps use gas
sealed in a high-pressure environment to emit a brilliant output.
Due to the high pressure involved with the construction of the lamp,
the lamp MAY EXPLODE DURING PROLONGED EXTENSIVE USE.
This risk is increased with age; added care is encouraged when
dealing with older lamps. Thus, the lamp must always be replaced
at the end of their recommended duty cycle. Extreme caution
should be used when operating this or any fixture fitted with a gas
discharge lamp.
UV RADIATION NOTICE
This fixture emits intense UV radiation, which is harmful to the eyes
and skin. The intense luminescence of the lamp can cause severe
damage to the retina. NEVER operate this fixture with ANY of the
protective covers removed. These covers have bee specially designed
to shield against UV radiation.
12