Carrying Handle - Chicco Sprint Instructions Manual

segment, is a fabric ring that can be used for
hanging soft toys. It comes with handy hooks
(figure 4 A).
INTERNAL COVERING AND COVER
5­ To fasten the internal covering to the carry cot:
Slip the plastic band located in the baby's
head zone between the styrofoam support
and the body of the carry cot; then fit the
fabric where the baby's feet will lie (diagram
5A). Fasten the cover in place using the two
side snap­buttons (diagram 5B) and insert
the eyelet over the relative hook where the
baby's feet will lie (diagram 5C). To guarantee
additional protection for your baby, thread
the two tape fasteners through the slots and
close the snap­buttons inside the hood, as
seen in diagram 5D.
The carry cot apron can be transformed into a
legcover for the stroller. Refer to the instruction
manual of the stroller for details related to assem­
bly of the legcover configuration.
ADJUSTABLE BACKREST -
COMFORT SYSTEM
6­ The backrest of the carry cot can be adjusted
gradually. To lift or lower the backrest use the
wheel located on the outer part of the carry cot
near the baby's feet (figure 6).
WARNING: It is advisable to ventilate the carry
cot after prolonged use.

CARRYING HANDLE

7­ The carry cot comes with a comfortable carry­
ing handle that can be adjusted in three posi­
tions (fig. 7):
A) Transport
B) Middle
C) Rest
8­ To put the handle in the vertical position, grasp
it in the centre and pull it upwards until you
hear a click (figure 8 A); to put the handle back
in the rest position press both buttons at the
base of the handle at the same time and then
turn it downwards (figure 8 B).
WARNING: Do not transport the carry cot with
the handle in the middle or rest position, but only
with the handle in carrying position.
WASHING
The hood, internal lining of the carry cot, and mat­
tress are removable and may be washed; it is ad­
vised to carefully follow the washing instructions
shown on the item's label.
9­ Remove the hood of the carry cot following
the instructions in point 3; then release the
two press studs that fasten the metal arch to
the fabric, and only pull out the metal arch by
pulling it from one of the two ends (figure 9);
do not pull out the rear arch with the 4 tabs
for washing.
10­ Remove the mattress padding through the
opening located on the back of the cover
(figure 10).
11­ To remove the carry cot internal lining, pull
the plastic strip, positioned where the baby's
head will lie, and slide it off the carry cot
(diag. 11).
The washing symbols and their significance are
as follows:
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
USING THE CARRY COT AS A BABY CARRIAGE
This carry cot can be used as a baby carriage
mounted on Chicco strollers that have the "Click
Clak" system.
HOW TO ATTACH THE CARRY COT TO THE
STROLLER
Prepare the stroller, equipped with the Clik Clak
system, to mount the carry cot as shown in the
instructions of the specific stroller.
NB: For strollers equipped with a backrest or
removable seat, it is advisable to unhook the
backrest or seat as shown in the specific stroller
instructions sheet.
12­ Grip the carrying handle in the transport posi­
tion and place the carry cot on the arms. The
baby's feet end of the carry cot should be
closest to the stroller's handle (figure 12).
13­ Align the pins on the two sides of the carry
cot with the openings located on the arms
of the stroller (figure 13 A), then carefully set
13