Safety Precautions WARNING • Read these Safety Precautions carefully before using the device in order to use it correctly. • Use the device sensibly in accordance with the prescribed steps. The following individuals should not use the device: • Immediately discontinue use and arrange to have the device repaired if any abnormality occurs. Failure to comply may cause accidents or other problems.
Page 3
WARNING WARNING If the device is dropped or Do not use, store or charge the device in the following locations: When disconnecting the plug damaged, turn off the power from a power outlet, pull it out by • In bathrooms or near bathtubs, showers, washbasins or other containers filled with water immediately, pull out the plug, grasping its head instead of the •...
Use in Foreign Countries ATTENTION Do not allow the device to come Do not press the device strongly or WARNING into contact with another beauty use it intensively on a single area. device or electronic appliance while Pressing the device stronger than the power is on.
Names of Components Before Use How to operate/How to read the display EYE Mode Electrodes Main Unit After switching <Front> Indicator and Buttons to EYE Mode LED Lamps • Connect the AC adapter to the adapter plug Electrode Head Level Indicator insertion port on the main unit and the wall socket, <Rear>...
Page 6
Modes • Be sure to move the device on your skin while using *1. If using your regular skin care LED Lamps (except in COOL Mode). products, be sure that they are water soluble. Do not use oil-based • Use only Level 1 upon the first use and until you are accustomed to use. or scrubbing skin care products.
Page 7
Level Indicator Pre-testing on Skin There are 5 levels for CLEAN and NEO DYHP Modes, and 3 levels for EYE Mode. * When using the device or a cosmetic product for the first time, always test for compatibility. Each time the CLEAN or NEO DYHP button is pressed, the level switches as shown in the below picture. * There is no level selection available for COOL Mode.
How to Use Remove all metal accessories (watches, necklaces, rings, earrings, etc.) when using the device. Failure to comply may cause accidents or injuries. Please reapply skin-care products or water during treatment to ensure that there is always some liquid between the electrode head and the skin.
Page 9
<NEO DYHP Mode> How to use the device on your skin Move the electrode head over the skin in the direction of the arrows shown below. • Recommended speed for moving the device: approx. 2 cm per second * If the temperature feels too hot, move the electrode head more quickly. •...
After Treatment Troubleshooting Checklist for Possible Problems How To Clean To keep the product clean, please be sure to clean it after each use. Problems Possible Causes Solutions Disconnect the AC adapter from the main unit and the wall outlet. The AC adapter is not →...
Page 11
Problems Possible Causes Solutions Frequently Asked Questions → → Lower the level using the The level setting is too high. Level button. EMS causes uncomfortable tingling or pain. Use a mirror to check that The entire surface of the → →...
Contacts for overseas customers Weight Main unit (with a cotton stopper): Approx. 230 g Please contact your local distributor or visit YA-MAN Global websites (https://www.ya-man.com/en/). Main unit: ABS resin Panel: Polycarbonate Materials Electrode head: PET resin and stainless steel...
Need help?
Do you have a question about the M30 and is the answer not in the manual?
Questions and answers