Summary of Contents for Sunlighten mPulse Discover
Page 1
Discover ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS included in door handle Philips Screw Driver Allen wrench Roof Floor Back Wall Right Wall Left Wall Front Wall Bench Glass Doors 11 in, 3 1/2 ft. sunlighten.com sunlighten.com...
Page 2
In this step make sure one person is holding the wall while the other helps balance it and press it in place. Front of sauna sunlighten.com sunlighten.com...
Page 3
A diagram showing the connection locations can be found on STEP 8. NOTE: If you ever have trouble getting a U-clip to slide in, this can be resolved by tapping it with a hammer. sunlighten.com sunlighten.com...
Page 4
There should be the connections to the lights and speakers at the top front. Connect those so you can turn on the lights and listen to sound. In addition there will be one metal-loop lead. Those can be screwed into the radio antenna. sunlighten.com sunlighten.com...
Page 5
There will be two screws to screw into the two holes on the corner where the two door thresholds meet. Back Wall Heaters Left Wall Heaters Right Wall Heaters Front Wall Heaters, Lights, Stereo, Control Tablet sunlighten.com sunlighten.com...
Page 6
Make sure the rough-texture side of the gasket is against the glass door as your insert it. This will give it the grip needed to hang it. Likewise, make sure the gaskets touching the hinges also are doing so by the rough side. sunlighten.com sunlighten.com...
Page 7
1/8 in. Open the glass door to 90°. Carefully remove the blue protection film. Make sure to clean the inside edge of the glass with a wet towel, then dry before applying the strips. sunlighten.com sunlighten.com...
Page 8
In case the strip hits the wooden frame, adjust the door hinge to increase the gap between the door and the wooden frame. CONGRATULATIONS, your sauna is now ready to enjoy! If you have any questions, please call Sunlighten Customer Support at 1-877-292-0020 x4 sunlighten.com sunlighten.com...
Need help?
Do you have a question about the mPulse Discover and is the answer not in the manual?
Questions and answers