Page 1
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Empower included in door handle Allen wrench Philips Screw Driver Roof Floor Back Wall Right Wall Left Wall with glass panel Front Wall Bench Glass Front Door 711x1750mm Glass Front Panel 164x1781mm 280m, 1050m sunlighten.com/gb-en...
Page 2
In this step make sure one person is holding the wall while the other helps balance it and press it in place. Front of sauna sunlighten.com/gb-en...
Page 3
A diagram showing the connection locations can be found on STEP 8. NOTE: If you ever have trouble getting a U-clip to slide in, this can be resolved by tapping it with a hammer. sunlighten.com/gb-en...
Page 4
Connect those so you can turn on the lights and listen to sound. In addition there will be one Lights, Speakers, metal-loop lead. Those can be screwed into the Antenna radio antenna. sunlighten.com/gb-en...
Page 5
The triangle support will need to be inserted underneath the left wall to support the left side of the bench. Right Wall Heaters Front Wall Heaters, Lights, Stereo, Control Tablet [6 connections] Back Wall Heaters Left Wall Heaters sunlighten.com/gb-en...
Page 6
Make sure the rough-texture side of the gasket is against the glass door as your insert it. This will give it the grip needed to hang it. Likewise, make sure the gaskets touching the hinges also are doing so by the rough side. sunlighten.com/gb-en...
Page 7
3mm. Open the glass door to 90°. Carefully remove the blue protection film. Make sure to clean the inside edge of the glass with a wet towel, then dry before applying the strips. sunlighten.com/gb-en...
Page 8
In case the strip hits the wooden frame, adjust the door hinge to increase the gap between the door and the wooden frame. CONGRATULATIONS, your sauna is now ready to enjoy! If you have any questions, please call Sunlighten Customer Support at 0330.808.1203. sunlighten.com/gb-en...
Need help?
Do you have a question about the mPulse Empower and is the answer not in the manual?
Questions and answers