Dometic D154F Installation And Operating Manual page 18

Installation
• Waste heat produced by the wine cooler must be extracted via ventilation open-
ings on the rear and at both sides.
6.3 Mounting the door handle
➤ Mount the handle as shown (fig. 6, page 6).
6.4 Adjusting the feet
➤ Make sure the wine cooler is level by adjusting the feet (fig. 7, page 6).
6.5 Changing the door hinge
fig. 8, page 7 – fig. 9, page 8
You can change the hinge of the door, so that it opens to the left rather than the right.
1. Proceed as shown to change the door hinge.
2. Reverse the door handle.
6.6 Connecting the wine cooler
Observe the following when connecting the wine cooler:
• Leave the wine cooler to stand upright for about 2 hours after transporting,
before you connect it to the power supply. Otherwise this could cause faults in
the cooling system.
• Connect the wine cooler to a circuit that is protected with 15 A.
• Have the socket and power circuit checked by a qualified electrician to ensure
that the socket is earthed correctly. Do not use an extension cable or a multiple
power socket.
• The power cable must rest securely behind the wine cooler and not be allowed
to lie or hang unprotected.
• Ensure that the power cable is not jammed when pushing the wine cooler into
place.
➤ Connect the plug of the connection cable into the AC mains.
✔ The display turns on.
18
D154F
EN