Download Print this page

progressive automations FLT-02 Assembly Instructions Manual page 5

Table lift set - dual - 3 step - stroke size 25.5
Hide thumbs Also See for FLT-02:

Advertisement

ASSEMBLY INSTRUCTIONS
STEP 6
Attach a Foot (P2) to the bottom of each Leg (P1) using
four M6x14 Machine Screws (P11) and tighten them until
fully secure.
STEP 7
Turn the assembled base right-side up to attach the ten
adhesive-backed Noise Attenuation Pads (P10). Put three on
each Side Bracket (P5) and two on the middle section of each
Crossbar End (P3).
STEP 8
The minimum table top size that should
be used is 43"x24"
Grab your table top and check if it's pre-drilled or not. Place
your assembled table lift upside-down on the underside of
your tabletop.
HOW TO ORDER
1.800.676.6123
You may need to adjust the width of the table lift to fit your
table top. To do this simply slide the two halves outward or
inward accordingly. We recommend leaving at least a half
inch overhang of the table top width over the table lift on
each side.
STEP 9
If your table top is pre-drilled go ahead to Step 10 and
come back to this after.
If it's not pre-drilled, secure the position of the Crossbar
Center Rails (P4) using eight M6x10 Machine Screws (P12).
Keep in mind the maximum width is 74".
|
sales@progressiveautomations.com
Caution: Ensure that the M6x10 Machine
Screws (P12) touches the Center Rails (P4)
by sliding the Center Rails (P4) as needed
|
www.progressiveautomations.com
Page 5 of 7

Advertisement

loading