Advertisement
ASSEMBLY INSTRUCTIONS
STEP 10
Caution: Double check that the wood
screws are not too long for your table
top and won't puncture the surface once
screwed all the way in
We recommend that you pre-drill any
holes needed for fasteners to connect
the Control Box (P6) or Remote
(P7) to the table top. NEVER use
countersunk screws
Double-check that the assembled table lift is properly
positioned on the underside of your table top.
Attach the table lift to the underside of the table top using
eight M5x20 ST Screws (P13). Use three for each Side
Bracket (P3) and 1 for each Crossbar End (P4).
Attach the Control Box (P6) to the underside of the table
top using two M5x16 Screws (P14). Make sure you have
enough space near the wire ports for cable connections.
Place the Remote (P7) so the front of it lines up with the
front edge of your table top. We recommend placing it
toward an end of your table top so it doesn't get in the way
while you're seated. Use two M5x16 Screws (P14) to attach
the Remote (P7) to the table top.
Caution: Do not overtighten screws.
Overtightening could cause damage
to components
HOW TO ORDER
1.800.676.6123
STEP 11
Connect the Cables (P9), Remote (P7) and the Power Cord
(P8) to the Control Box (P6). Use the adhesive backed Cable
Clips (P15) to secure the Cables and Remote cable so they
aren't loose.
STEP 12
For this step we recommend using two people. With a
person on each side, grab the table lift by the BASE (not the
table top) and turn the fully assembled table lift right-side-
up. Adjust the pre-installed Leveling Studs if need be.
STEP 13
Plug the power cord into a 110V outlet.
IMPORTANT
You MUST reset the table lift prior to use.
To reset you must push and hold the DOWN button on
the remote (P7) until the table lift reaches its lowest point,
slightly rises and then stops completely. Release the DOWN
button and your table lift is ready for action.
To program up to four presets with the remote just use the
Up/Down buttons to find your desired height, then press
the "M" button followed by a number 1-4.
|
sales@progressiveautomations.com
Caution: Make sure no obstacles are
in the table lifts path and the top is
not touching any walls. Make sure all
the cords are the correct length to
accommodate the change in height
Caution: Ensure the cables are not
obstructing the path of either of the Legs
(P1) before proceeding
Caution: Once a preset button is pushed,
the table lift will move to the programmed
height (see caution box above).
|
www.progressiveautomations.com
Page 6 of 7
Advertisement
