Advertisement
ASSEMBLY INSTRUCTIONS
STEP 1
Before you start make sure to lay out all the components
and hardware to ensure you have all the necessary
components and hardware listed on the parts page.
Separate the Crossbar Ends (P3) and you will find the
Crossbar Center Rails (P4) inside.
STEP 2
Place one of the Legs (P1) into the Crossbar End (P3) making
sure that the bar is on the top side in relation to the Leg (P1).
Then line up the holes on each Leg (P1) with the holes on each
Crossbar End (P3).
STEP 3
Insert four M6x14 Machine Screws (P11) through the holes
on each Crossbar End (P3) going into the Leg (P1). Rotate
each screw with the supplied Allen Wrench a just a few
turns, we don't want to tighten them just yet.
Caution: DO NOT tighten the screws
If you drop a screw inside the Crossbar
End (P3), just tilt it until the screw falls out
HOW TO ORDER
1.800.676.6123
STEP 4
Take the Side Bracket (P5) and insert four M6x14 Machine
Screws (P11) through the four holes going into the
assembled Crossbar End/Leg. Like the previous step use
the Allen Wrench to rotate the screws just a few turns.
Repeat Steps 1-4 for the other Leg (P1) and Crossbar End
(P3). Once you are finished you can now tighten the screws
from Steps 3 and 4 until they are fully secure.
STEP 5
Slide the two Crossbar Center Rails (P4) into the two
assembled Crossbar Ends (P3). Make sure that the slots face
inward and that the slot is closer to the top edge of the
Crossbar Center Rail (P4) while the assembly is upside down.
|
sales@progressiveautomations.com
If you are having difficulty inserting any
of the screws from Steps 3 or 4 it is most
likely because the screws are too tight
at this point
|
www.progressiveautomations.com
Page 4 of 5
Advertisement
