Fasten Psg2 - panel PC PSG2-EP Series User Manual

When installing the PSG2 in a slanted panel, and the panel face inclines more than 30°, the surrounding air temperature
must not exceed 40°C. You may need to use forced air cooling (fan, A/C) to ensure the surrounding air temperature is
40°C or below.

3.3 Fasten PSG2

Insert the PSG2 into the panel cut. When inserted, fix the Panel PC as shown:
(1) Insert each of the fasteners, as shown. Be sure to pull the fastener back until it is flush with the rear of the
attachment hole.
(2) Be sure to pull the fastener back until it is flush with the rear of the attachment hole.
(3) Tightening the screws with too much force can damage the PSG2 unit's case
The torque required to tighten these screws is 0.5 Nm.
www.panel.it 13
13