Fasten Psr1 - panel PSR1-FO Series User Manual

3.3 Fasten PSR1

Insert the PSR1 into the panel cut. When inserted, fix the Panel PC as shown:
(1) Insert each of the fasteners, as shown. Be sure to pull the fastener back until it is flush with the rear of the
attachment hole.
(2) Be sure to pull the fastener back until it is flush with the rear of the attachment hole.
(3) Tightening the screws with too much force can damage the PSR1 unit's case
The torque required to tighten these screws is 0.5 Nm.
www.panel.it 14
14