Installation Procedures - PEP CP381 Manual

30 channel compactpci digital input controller
Table of Contents

Advertisement

Installation
3.1.2

Installation Procedures

To install the board proceed as follows:
1. Ensure that the safety requirements indicated above are observed.
Warning!
Failure to comply with the instruction below may cause damage to the board or
result in improper system operation. Please refer to chapters 4 and 5 for config-
uration information.
2. Ensure that the board is properly configured for operation before installing.
Note...
Care must be taken when applying the procedures below to ensure that when
the board is inserted it is not damaged through contact with other boards in the
system.
3. To install the board perform the following:
1. Prior to installation of the board disengage the insertion/extraction handle by first un-
locking the handle and pressing it down.
2. Insert the board into an appropriate slot, and, using the insertion/extraction handle, en-
sure that it is properly seated in the backplane. (Front panel is flush with the rack front;
the insertion/extraction handle is locked.)
4. Fasten the front panel retaining screws.
Warning!
Proper and safe operation of the CP381 Digital Input Controller depends on the
correct configuration of input signals and signal conditioning. System
integrators must ensure that all signals presented to the CP381 comply with the
specifications set forth in this manual.
Failure to comply with the above may cause damage to the board or result in
improper system operation. Please refer to chapters 4 and 5 for configuration
information.
5. Connect external interfacing cables to the board as required.
6. Ensure that the interfacing cables are properly secured.
Page 3 - 4
© 2002 PEP Modular Computers GmbH
CP381
ID 24107, Rev. 01

Advertisement

Table of Contents
loading

Table of Contents