Dispensers - Maytag BRAVOS W10420493A Use And Care Manual

Maytag washer user manual
Table of Contents

Advertisement

Available languages

Available languages

CYCLE STATUS LIGHT INDICATORS
8
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from traditional washers.
FILL
When the Start/Pause button is pressed, the washer
will add a small amount of water to the load, then
pause for a few seconds. The lid will then lock and
the washer will continue to fill.
WASH
You will hear the motor and washplate moving the
load. Unlike traditional washers, the load is not
covered with water. Low-water cleaning means
concentrated cleaning. Rather than diluting detergent
as done in an agitator-style washer, this washer
delivers the detergent directly to the soils. The motor
sounds may change at different stages in the cycle.
The wash time is determined by the selected Soil
Level.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briefly (short hum) to move the basket
while filling. Fabric softener will be added if the Fabric
Softener option was selected. Some cycles use spray
rinsing.

DISPENSERS

High Efficiency "HE" detergent dispenser
A
Add liquid or powdered HE detergent
to this dispenser for your main wash cycle.
Use only High Efficiency (HE) detergent.
Liquid chlorine bleach dispenser
B
This dispenser holds up to 3/4 cup (180 mL) liquid
chlorine bleach. The bleach will be automatically diluted
and dispensed at the optimum time during the the wash
cycle. This dispenser cannot dilute powdered bleach.
NOTE: Fill dispenser only with liquid chlorine bleach.
Liquid fabric softener dispenser
C
Pour measured liquid fabric softener into the liquid
fabric softener dispenser, if desired. It will dispense
automatically at the optimum time when the Fabric
Softener option is selected.
• Use only liquid fabric softener in this dispenser.
SPIN
The washer spins the load at increasing speeds for proper
water removal, based on the selected cycle and spin speed.
DONE
Once the cycle is complete, this light will come on. Remove
the load promptly for best results.
ADD A GARMENT
You may place additional garments in the wash when
the Add a Garment indicator light is glowing without
sacrificing wash performance. Press START/Pause once.
The Lid Lock light will turn off. Open the washer lid, add
garments and close the lid. Press START/Pause to restart.
CLEAN WASHER REMINDER
The Clean Washer Reminder indicator lights after 30 wash
cycles without a clean washer cycle. See the "Cleaning Your
Washer" section to run the clean washer cycle, or you can
press REMINDER RESET button to manually reset clean
washer cycle counter.
B
A
C
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents