Variables - Nokia IP350 Appliance Installation Manual

7
Using the Boot Manager
the hard-disk drive. You can set these values by using boot manager
commands.
This chapter describes the boot manager commands.

Variables

A number of variables are stored by the boot manager in nonvolatile memory.
You can set and view most variables from the boot manager prompt. The
following sections describe how to view and set the variables. The variables
are:
Table 4 Boot manager variables
Variable
boot manager
revision
autoboot
bootwait
74
All manuals and user guides at all-guides.com
Description
The version number of the boot manager. This variable
cannot be set from the command line.
If autoboot is set to no, the IP350 or IP380 appliance stops
at the boot manager command line during the boot process.
If autoboot is set to yes, the IP350 or IP380 appliance does
not stop at the boot manager command line during a boot
up. It does wait for the amount of time specified in
for input from the keyboard. If input is received,
bootwait
the boot manager goes to the command line; otherwise, it
proceeds with the boot up.
Factory default: yes.
The amount of time, in seconds, that the boot manager waits
for input during a boot up when autoboot is set to yes.
Factory default: five seconds.
IP350 and IP380 Appliance Installation Guide