Trane Tracer AH541 Installation Sheet
Hide thumbs
Also See for Tracer AH541:
- Setup and operation (134 pages) ,
- Installation owner diagnostics (96 pages) ,
- Installing (9 pages)
Advertisement
Installation Sheet
Frame-mounted Tracer™ AH541 Controller
Order Numbers: BMTA000CAB00
The frame-mounted Tracer AH541 controllers can be used to replace controllers in existing equipment or mounted in new
equipment or custom enclosures.
Warnings, Cautions, and Notices
Warnings, cautions, and notices are provided in appropriate places throughout this document:
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious
WARNING:
injury.
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate
CAUTION:
injury. It may also be used to alert against unsafe practices.
Indicates a situation that may result in equipment or property-damage only accidents.
NOTICE:
NOTICE
Avoid Equipment Damage!
Install and use the controllers as specified by the manufacturer. Failure to do so may result in equipment damage.
June 2008
© 2008 Trane. All rights reserved
3270 3403 D
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Trane Tracer AH541
Summary of Contents for Trane Tracer AH541
- Page 1 Installation Sheet Frame-mounted Tracer™ AH541 Controller Order Numbers: BMTA000CAB00 The frame-mounted Tracer AH541 controllers can be used to replace controllers in existing equipment or mounted in new equipment or custom enclosures. Warnings, Cautions, and Notices Warnings, cautions, and notices are provided in appropriate places throughout this document:...
- Page 2 Frame-mounted Tracer™ AH541 Controller Operating Environment Requirements Make sure that the operating environment conforms to the specifications listed in Table Table 1. Specifications Temperature: From -40°F to 158°F (-40°C to 70°C) Humidity: 5–95% non-condensing Power requirements: 21–27 Vac (24 Vac nominal) Altitude: 6500 ft (2000 m) Installation:...
- Page 3 Frame-mounted Tracer™ AH541 Controller Installing the Termination Board To install the termination board: 1. Remove the controller from its packaging and separate the top and bottom frames. 2. Using the bottom frame (with the termination board) as a template, mark the location of the four mounting holes and the grounding screw on the mounting surface.
- Page 4 Frame-mounted Tracer™ AH541 Controller Installing the Main Circuit Board The controller does not ship with the top plastic frame installed. The board can be kept in the office and programmed while the enclosure is mounted and wired. After programming has been completed, connect the circuit board to the termination board.
- Page 5 Frame-mounted Tracer™ AH541 Controller Figure 3. Installing the main circuit boards Grounding screw Ensure that the slot keys are aligned when connecting the 60-pin cable to the 60-pin cable ejector. Important: The 60-pin cable ejector is designed to eject the 60-pin cable when disconnecting (refer to the lower right inset above). 1.
- Page 6 This document validates CE conformity of the Tracer AH541 modular configurable controller. Tracer, Trane, and the Trane logo are trademarks of Trane in the United States and other countries. All trademarks referenced in this document are the trademarks of their respective owners.
Need help?
Do you have a question about the Tracer AH541 and is the answer not in the manual?
Questions and answers