Network Setup - Maxtor 4-Channel DVR (Digital Video Recorder) User Manual

SENSOR/ MOTION SETUP
SENSOR/ MOTION RECORD TIME
ALARM OUT TIME
SENSOR TYPE
>CH-1 NOT INSTALLED
CH-2 NOT INSTALLED
CH-3 NOT INSTALLED
CH-4 NOT INSTALLED
PRESS (UP, DOWN) , THEN (SELECT)
PRESS (MENU) TO EXIT
In NORMAL-CLOSE mode, if an intruder cuts the cable line that connects the sensor to the DVR, sensor
recording starts automatically. In NORMAL-OPEN mode, if an intruder cuts the cable line that connects
the sensor to the DVR, the sensor recording will not start at all.
MOTION SETUP
There are 5 different modes for sensor activated recording:
1. OFF: No motion direction is connected to the DVR unit.
2. Level 1~4: Level 4 is the most sensitive.

NETWORK SETUP

NETWORK SETUP is available for this DVR.
If you plan to connect your DVR unit to a network, navigate to NETWORK SETUP.
MAIN MENU
CAMERA SELECT
RECORD SELECT
RECORD MODE
RECORD FRAMERATE
VIDEO QUALITY
RECORD SCHEDULE
SUB MENU
HARD DRIVE SETUP
SENSOR / MOTION SETUP
> NETWORK SETUP
Then, press the select button
NETWORK SETUP
> ACCEPT CLIENT
MAC ADDRESS
IP ADDRESS
SUBNET MASK
GATEWAY
PRESS (UP, DOWN) , THEN (SELECT)
PRESS (MENU) TO EXIT
10
00
MOTION
LEVEL4
LEVEL4
LEVEL4
LEVEL4
1234
1234
EACH
30
NORMAL
to display the following menu:
[YES]
00.22.24.23.25.26
192.168.001.090
255.255.255.000
192.168.991.245
26