Sensor/ Motion Setup - Maxtor 4-Channel DVR (Digital Video Recorder) User Manual

SENSOR/ MOTION SETUP

To set up recording that is activated by a motion sensor connected to the DVR, navigate to SENSOR
SETUP
MAIN MENU
CAMERA SELECT
RECORD SELECT
RECORD MODE
RECORD FRAMERATE
VIDEO QUALITY
RECORD SCHEDULE
SUB MENU
HARD DRIVE SETUP
> SENSOR / MOTION SETUP
Then, press the select button
SENSOR / MOTION SETUP
> SENSOR/ MOTION RECORD TIME
ALARM OUT TIME
SENSOR TYPE
CH-1 NOT INSTALLED
CH-2 NOT INSTALLED
CH-3 NOT INSTALLED
CH-4 NOT INSTALLED
PRESS (UP, DOWN) , THEN (SELECT)
PRESS (MENU) TO EXIT
SENSOR / MOTION RECORD TIME:
last detection of movement.
Indicates how long the alarm lasts after it sets off.
ALARM OUT TIME:
SENSOR / MOTION RECORD TIME and ALARM OUT TIME are measured in seconds.
Note: You must have sensors connected to your DVR unit to use this feature. For more information on
sensors, refer to Chapter 5 – SENSOR/ MOTION DETECTOR INSTALLATION on page 15.
SENSOR / MOTION SETUP (CONTINUED)
There are 3 different modes for sensor activated recording:
1. NOT INSTALLED (no sensors are connected to the DVR unit)
2. TYPE: NORMAL-CLOSE
3. TYPE: NORMAL-OPEN
The type of sensor should be selected to match the type of sensor connected to your DVR. Check the
materials that came with your sensor, or contact the manufacturer to see what type of sensor you have.
To set the mode for sensor activated recording, navigate to each channel and press the select
button to choose either NOT INSTALLED, TYPE: NORMAL-OPEN, or TYPE: NORMAL-CLOSE.
1234
1234
EACH
30
NORMAL
to display the following menu:
10
00
MOTION
LEVEL4
LEVEL4
LEVEL4
LEVEL4
Indicates the time recording period after the sensor or motion's
25
SELECT