Safety System; Preparing The Product For Use; Switching On / Off / Selecting The Temperature; Temperature Levels - Silvercrest SFW 100 B2 Operating Instructions And Safety Advice

Important safety instructions / Safety system / Preparing the product for use
or damage. If you find such signs of damage,
if the cables are damaged or if the foot
warmer has not been used properly, it must be
returned to the manufacturer or to the service
department before it is used again. There is a
danger of electric shock and injury.
Repairs must only be carried out by specially
trained personnel or at a repair shop author-
ised by the manufacturer, since special tools
are necessary. Unsatisfactory repairs can lead
to considerable danger for the user.
Only have the foot warmer re-
paired by qualified specialist personnel using
OEM spare parts. This will ensure your foot
warmer remains safe to use.
If the mains power cable of the
foot warmer is damaged, it has to be replaced
by the manufacturer or its service department
or a similarly qualified person in order to avoid
hazards.

Safety system

Note: This foot warmer is equipped with a safety
system. The electronic sensor technology prevents
the entire surface of the foot warmer from overheat-
ing by automatically switching off in the event of a
fault. If the safety system switches the foot warmer
off automatically due to a fault, then the function
display on the control unit
3
minated, even if the heating pad is switched on.
Please note that, for safety reasons, the foot
warmer must not be used after a fault and must
be returned to the service address indicated.

Preparing the product for use

Note: When the foot warmer is used for the first
time, you may notice a smell of plastic; however,
this will disappear after a short time.
90994_silv_Fußwaermer_content_LB3 (GB-DK-BE).indd 9
Switching on:
Switching off:
Note: the function display
Selecting the temperature:
is no longer illu-
2
Level 0:
Level 1:
Level 2 - 5:
Level 6:
Switching on / off / Selecting
the temperature
Insert the mains plug into the mains socket.
Set Level 1, 2, 3, 4, 5 or 6 on the control
unit to switch the foot warmer on.
2
Note: The function display
after the foot warmer is switched on.
Note: This foot warmer features rapid heating,
which allows it to heat up within the first 15
minutes of operation.
Set Level 0 on the control unit
foot warmer off.
3
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
If you are going to use the foot warmer for a
number of hours, set it to the lowest tempera-
ture setting (setting 1).
The foot warmer can of course be used at any
time if it is switched off. Its teddy plush lining
will warm your feet even if an electric socket is
nowhere near.

Temperature levels

Set the required temperature level on the
control .
2
Off
minimum heat
Customised heat
maximum heat
illuminates
3
to switch the
2
ceases to illuminate.
GB 9
29.05.13 09:50