Adjustment Standard (Charger Unit) - Panasonic KX-TCD510ALV Service Manual

Items
(A Charging
) Check
Note:
After the measuring, sock up the solder of TP.
The connection of adjustment equipment are as shown in

14.4. Adjustment Standard (Charger Unit)

When connecting the Simulator Equipments for checking, please refer to below.
14.4.1. Flow Solder Side View
Note:
(A) is refered to ADJUSTMENTS (BASE UNIT AND CHARGER UNIT)
15. ADJUSTMENTS (HANDSET)
If your unit have below symptoms, adjust or confirm each item using remedy column from the
table.
The movement of Battery Low indicator is wrong.
The handset does not respond to a call from base unit.
The handset does not transmit or the transmit frequency is off.
The transmit frequency is off.
The transmit power output is low, and the operating distance
between base unit and handset is less than normal.
The reception sensitivity of base unit is low with noise.
Does not link between base unit and handset.
The Audio level is high or low.
The SP-Phone level is high or low.
The Headset level is high or low.
* : Refer to Adjustment (Handset)
15.1. Adjustment (Handset)
Adjustment
Point
1. Connect Charge Contact 12
-
2. Measure and confirm voltage across the regigster is 2.7V ± 0.2V.
Symptom
()
Procedure
/2W register between charge+ and charge-.
Adjustment Standard (Charger Unit)
58
()
Remedy*
Make adjustments in item (A)~(
).
Make adjustments in item (A)~(
Make adjustments in item (A)~(
(M), (O).
Make adjustments in item (A)~(
(M), (O).
Make confirmation in item (J),
Make confirmation in item (N).
Make adjustments in item (A)~(
Make confirmation in item (R).
Make confirmation in item (S).
Make confirmation in item (T).
Check
D1,R1,R2
().