Table of Contents
Advertisement
JUICE EXTRACTOR
OPERATION
1. Make sure your Juice Extractor Attachment is
properly assembled and attached to the
motor base.
2. Plug the power cord into the electrical outlet.
3. Wash all selected fruits or vegetables.
4. While many fruits and vegetables will not
need cutting, any item with a diameter larger
than 5cm will need to be cut.
5. Turn the dial from the OFF position to HIGH.
A blue light ring will blink on the power dial to
indicate the unit is ready to operate.
6. Push the juice spout down to the open
position before juicing.
7. Lift the food pusher out of the feed tube and
drop your food into the opening. Push
through by inserting the food pusher
and pressing firmly. Do not pack the feed tube
too full of food. Be sure that the food has
been processed through the filter basket/
blade before adding more items. When using
the pusher, use gentle pressure to guide food
through the feed tube. Do not press too hard
or use too much force.
8. The juice will flow into your glass and the pulp
will accumulate in the pulp container.
9. When finished juicing, turn the dial to the OFF
position to stop the motor.
JUICE EXTRACTOR
DISASSEMBLY
1. Unplug the Juice Extractor.
2. Unlock the locking clamps and cover then
remove the pusher.
3. Lift and remove cover from filter housing.
4. Carefully remove mesh filter basket/blade
from the filter housing by pulling up on the
sides of the rim. Be careful not to touch the
blades in the bottom of the basket.
5. Remove the pulp container from the side of
the motor base and empty.
CLEANING AND
MAINTENANCE
Always unplug your Cuisinart
Juicer & Blender from the electrical outlet before
cleaning. The base and parts are made of
corrosion-resistant materials that are easy to
clean. After every use, clean each part thoroughly.
Periodically check all parts before reassembly. DO
NOT USE IF ANY PART IS DAMAGED, OR IF
THE BLENDER CUP IS CHIPPED OR CRACKED.
To remove blade assembly, twist off by turning
clockwise.
NEVER TOUCH THE BLADE.
CAUTION: Handle the blade assembly carefully.
Blades are SHARP and may cause injury. DO NOT
attempt to remove blades from cutting assembly,
do not attempt to detach the blade assembly
from Blade collar.
Wash all parts in warm, soapy water. Rinse and
dry thoroughly. All parts are top rack dishwasher
safe.
Blender Cleaning Tips: You may wish to clean
your blade assembly as follows: squirt a small
amount of dishwashing liquid into blending cup
and fill halfway with warm (not hot) water. Attach
blade assembly and run on Low or Pulse for 15
seconds. Repeat, using clean tap water. Carefully
disassemble parts and empty blending cup. Rinse
and dry all parts thoroughly.
Juicer Cleaning Tips:
To ensure consistent juicing results, always clean
the filter basket thoroughly immediately after use.
If pulp is left to dry, it may clog the fine pores of
the filter mesh, which can affect juicing
performance. The filter basket can be soaked in
hot soapy water for a few minutes if necessary.
Filter basket can be washed in the top rack of the
dishwasher.
CAUTION: The center of the filter basket has an
array of small, sharp blades. Do not touch these
blades when handling the filter basket.
Base Cleaning Tips: Wipe the motor base clean
with a damp cloth to remove any residue, and dry
thoroughly. Never submerge the motor base in
water or other liquids, or place in a dishwasher.
Any other servicing should be performed by an
authorized service representative.
Pulp Container Cleaning Tips: The pulp container
is easier to clean if lined with a plastic bag. This
may also prevent staining of the pulp container
over time with use.
8
®
Kick Start Personal
Advertisement
Table of Contents
