Table of Contents
Advertisement
BLENDER TROUBLESHOOTING
My blender is not turning on
The blender stops running
The blade assembly is hard to remove after
blending
Unit appears to be leaking
Problem:
Be sure the blade assembly is on the
blending cup correctly and locked into place
Plug the blender into an independent and
electrical outlet and make sure the blender is
securely plugged in. If it still doesn't work, try
plugging into a different outlet and/or check
your home's circuit breaker.
The blender has an auto stop feature. After 60
seconds or if blending heavy loads for extended
periods the motor overload feature may be
activated.
To reset, unplug and allow the blender to cool
for a minimum of 15 minutes.
Reduce the contents of the blending cup and/or
clear any jams.
The ingredients cause pressure, and with the air-
tight seal, pressure builds up creating a vacuum
or a suction effect. This is normal.
Check rubber gasket and make sure it's flush
with the blender assembly. You can also check
the rubber gasket to see if is in place or even
damaged. The blade assembly should be tight.
Replacement rubber gaskets can be purchased
as a spare part.
9
Solution:
Advertisement
Table of Contents
