Rinsing - Panasonic NA-W120G1 Operating & Installation Instructions Manual

Rinsing

5 4
1 2,4
Rinse with water saving
1. Fill the wash tub with water up to the water level depending on the laundry amount, and then turn off the
water faucet.
2. Set the wash time to 2-3 min. by turning Wash Timer for rinsing.
3. Set the spin time to 2-3 min. by turning Spin Timer for spinning.
4. After draining water, perform 2nd rinsing in the same way with the steps 1-3 shown above.
Rinse with water supplying
1. Fill the wash tub with water up to the water level depending on the laundry amount.
2. Set the wash time to 5 min. or 7 min. by turning Wash Timer for rinsing.
Note
Keep the state of water supplying.
Make sure to close the lid of Wash Tub. If not, filled water may splash out from the tub when water supply
is too much.
3. Set the spin time to 2-3 min. by turning Spin Timer for spinning.
1 3 2
3
Midterm Spinning
After the wash process ended, put the washed
1.
clothes into the spin tub.
Place the spinner cap in the tub and close the
2.
spinner lid. (See P.10 "Spinning" for details about
the spinner cap).
Set the spinning time to 2-3 min. by turning the
3.
spin timer.
To perform "Foam removing by Spinning"
After Step 3, Spinning with water supplying can
be operated to dilute detergent, so that rinsing
time and water will be saved. (Do not perform
this step to avoid clothes stained if water is
contaminated with reddish rust or so.)
4. Set the water supply selector to the spin tub
then turn on the water faucet and supply water
for about 1 min.
5. Turn off the water faucet and operate spinning
for 2-3 min.
Rinsing
After the midterm spinning process ended, put
1.
the clothes back to the wash tub.
2. Set the Wash / Cycle selector to "Regular" or "Gentle".
3. Set the water supply selector to the wash tub.
Select the way of Rinsing, "Rinse with water
4.
saving" or "Rinse with water supplying".
R
T
9