Maintenance; Troubleshooting - Panasonic NA-W120G1 Operating & Installation Instructions Manual

Maintenance

Be sure to remove the power plug from the power outlet before cleaning the machine and lint filter.
How to clean the Lint Filter
1.
Pull out the lint filter from the
lock.
By using fingers to press and
pull out at the upper part of
the lint filter's side.
The laundry or button is stuck into the pulsator.
If the buttons, coins or the like wedged in the gap pulsator and cannot be taken, contact your nearest
service center.

Troubleshooting

If any abnormality is found, check the following before calling for service:
1. Is the power plug inserted firmly or power cord disconnected?
2. Is the fuse blown?
3. Is the timing switch turned to "off" position?
4. Is the spinner lid closed properly?
5. Is there any laundry fallen out from the spinner tub?
If all the above points have been checked and no abnormality is found but the machine still work improperly,
please contact the service center.
Long term use product confirmation
● The power cord or plug set is hot
● Unscented odor such as burnt or odor,
abnormal vibration or abnormal
Does the
sound during operation
product have ● Spin tub does not stop properly
● Water leakage
symptoms on
(water supply pipes, drain pipes, etc.)
the right?
● When there is a feeling of electric leakage
and numbness when touching the product
● Other abnormal malfunction
2.
Rinse the dirt from the filter
with water.
3.
Set it back to the original
position.
- Insert the bottom first as
shown in the figure.
- Press down and lock as the
arrow.
If the product has such symptoms,
in order to prevent the malfunction
or the expansion of the accident,
please turn off the power of
the product, unplug the
plug, and contact the nearest
Panasonic service personnel for
inspection or repair.
R
T
11