Advertisement
Study Desk a Desk and Ch and Chair
Instruction Manual
Model: DESK-V DESK-V402P V402P
Email: help@vivo-us.com
Live chat: www.vivo-us.com
Call: 1-800-371-5654
-
Scan the QR code with your mobile device or follow the link
to helpful videos and specifications related to this product.
https: DESK-V / /vivo us.com/products/desk and Ch v402p
-
Tools Required: DESK-V
phillips screwdriver
Pack and Ch a ge Contents
A1 (x12)
A2 (x8)
Plast Bar i c Washer Washer Suppor
Shor Suppor t Bar Bolt Bar
A5 (x4)
A6 (x2)
Long Bolt Bolt Bar
Knob
B1 (x1)
B2 (x1)
Chair Suppor Leg Bolt
Cent Bar e r Suppor Bar Suppor
B5 (x1)
B6 (x1)
Plast Bar i c Washer Seat Bar Bac Washer k Nut
Desk Nut Leg Bolt s
-
A3 (x4)
A4 (x4)
Sc Washer r Suppor e w
Loc Washer k Nut Nut Bar
A7 (x1)
A8 (x1)
Allen Wr Suppor e nc Washer h
Hook Nut
B3 (x1)
B4 (x1)
Rear Suppor Suppor Suppor t Bar Bar Suppor
Plast Bar i c Washer Seat Bar
Bot Bar t Bar o m
B7 (x1)
B8 (x1)
Desk Nut Suppor Suppor t Bar Bar Suppor
Desk Nut
1
Advertisement
Table of Contents
Related Manuals for Vivo DESK-V402P V402P
Summary of Contents for Vivo DESK-V402P V402P
- Page 1 Scan the QR code with your mobile device or follow the link to helpful videos and specifications related to this product. https: DESK-V / /vivo us.com/products/desk and Ch v402p Tools Required: DESK-V phillips screwdriver Pack and Ch a ge Contents...
- Page 2 Chair Assembly Desk a Steps Step 3 Step 1 Slide plastic seat back (B5) onto Attach rear support bar (B3) to back of chair legs (B1) using 4 short bolts (A2) and 4 chair frame, aligning upper or lower plastic washers (A1), leaving the bolts slightly loose. Place center bar (B2) into large holes in seat back with screw holes holes on left and right chair legs (B1), then tighten bolts on rear support bar using in frame depending on the needed...
- Page 3 Desk and Ch Assembly Desk a Steps Step 8 Step 6 Loosen knobs on sides of desk to raise the desktop, then secure desk to frame Attach desk support bar (B7) to back of desk legs (B6) using 4 short bolts (A2) and 4 using 4 long bolts (A5) with 4 plastic washers (A1) and 4 lock nuts (A4), and tighten plastic washers (A1), then tighten bolts on rear support bar using the Allen wrench with the Allen wrench.
- Page 4 Step on support bar with one foot and pull up with even motion until the desk/chair reaches max height, then fully lower. Tighten knobs or screws. For more VIVO products, check out our website at www.vivo-us.com.
Need help?
Do you have a question about the DESK-V402P V402P and is the answer not in the manual?
Questions and answers