Advertisement
Quick Links
Model 72
Place pump flange over the motor.
Align the four flange holes with the
four motor holes. -SEE FIGURE 1
Install four bolts and washers into the
four holes of the pump flange. -SEE
FIGURE 2
Using a drill, tighten bolts in an 'X'
pattern. Use a ratchet and check the
bolts to ensure tightness.-SEE FIGURE
3
Figure 2
Figure 1
Figure 3
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Speck 72
Summary of Contents for Speck 72
- Page 1 Model 72 Place pump flange over the motor. Align the four flange holes with the four motor holes. -SEE FIGURE 1 Install four bolts and washers into the four holes of the pump flange. -SEE Figure 1 FIGURE 2 Using a drill, tighten bolts in an ‘X’...
- Page 2 Model 72 Place two small drops of loctite, one on each side, on the motor shaft threads. –SEE FIGURE 5 Figure 5 Spin the impeller onto the motor shaft in a clockwise direction until you feel the two sides of the seal make contact.
- Page 3 Model 72 Install the diffuser and casing o- ring back into place. - SEE FIGURE 8 Place the casing assembly over Figure 8 top of the diffuser. - SEE FIGURE Place screws through the outside holes on the pump flange. Tighten screws in an X pattern.
- Page 4 Model 72 Last, install two Legos behind flange. - SEE FIGURE 11 Figure 11...
Need help?
Do you have a question about the 72 and is the answer not in the manual?
Questions and answers