Advertisement
Reassembly
1. Replace valve plate (75) with ribs facing up toward
ribs on head (74).
2. Replace three bolts (100) and use 1/2 in. socket to
tighten head (74). Torque all three bolts to 75 in-lb,
then torque all bolts again to 210 in-lb.
3. Install cooling tube (71) by tightening two cooling
tube nuts (70).
100
74
70
71
4. Replace compressor and shroud:
a. Install compressor shroud with two screws.
Install IEC cord clamp with two screws.
ti13414a
313770A
75
70
ti13937a
ti13664a
b. Install air inlet fitting.
c. Tip compressor assembly up and back into
frame. Install four screws.
d. Install IEC connector and tighten cord clamp.
Install air hose to outlet fitting. Make sure cord is
pushed in as far as it can go to ensure a good
connection.
ti13411a
ti13442a
ti13420a
3
Advertisement
