Download
Share
Print this page
  1. Manuals
  2. Brands
  3. EDLUND Manuals
  4. Kitchen Appliances
  5. 610
  6. Service manual

EDLUND 610 Service Manual

Crown opener
Hide thumbs Also See for 610:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
https://appliancetechmanuals.com
M098 – REV B (JULY 2006)
SERVICE MANUAL M098
MODEL # 610
CROWN OPENER
Page 1 of 8
8/4/2010

Advertisement

loading

Related Manuals for EDLUND 610

Summary of Contents for EDLUND 610

  • Page 1 M098 – REV B (JULY 2006) SERVICE MANUAL M098 MODEL # 610 CROWN OPENER Page 1 of 8 8/4/2010...

  • Page 2: Safety Precautions

    M098 – REV B (JULY 2006) Model 610 Crown Can Opener SAFETY PRECAUTIONS WARNING! 1) Do not allow any person near knife or lid remover while machine is being operated. The fast, high forces of air cylinders that operate the blade and lid remover can cause serious injuries. The two hand controls and guards keep the operator away from these sharp, moving parts.

  • Page 3: Cleaning Instructions

    https://appliancetechmanuals.com M098 – REV B (JULY 2006) Blade Cleaning and Inspection CLEANING INSTRUCTIONS 1) Disconnect air supply. Remove guard ring, blade clip and knife and wash after use. Remove two knurled screws that hold the guard ring in place. It may be necessary to pull down on the guard ring to remove it if the locating pins are too tight.

  • Page 4: Setup And Operation

    https://appliancetechmanuals.com M098 – REV B (JULY 2006) SETUP AND OPERATION 1) Unpack can opener and check for any loose screws or any damage. 2) Place can under the guard ring and against the locator. The can should be centered 3/16” under the ring. 3) Connect the airline.
  • Page 5 M098 – REV B (JULY 2006) 610 Operation and Troubleshooting Operation Description 1. Place can in position against guard ring tab. There should be approximately 1/8" between the top of the can and the bottom of the guard ring. Adjust, if necessary, keeping the head level and spaced evenly.
  • Page 6 https://appliancetechmanuals.com M098 – REV B (JULY 2006) Symptom 2. Air leaks out around The cover must be removed to pinpoint leaks. Worn seals cylinder shaft near blade. usually cause cylinder end leaks and the cylinder must be removed and repaired or replaced. 3.
  • Page 7 M098 – REV B (JULY 2006) 610 PARTS LIST CO M P # DESCRIPTION A 6 0 0 W e l d m e n t , Fr am e (A 7 4 9 , F0 5 2 [4 ], R0 2 1 , R0 4 6 , S2 2 3 )
  • Page 8 M098 – REV B (JULY 2006) EDLUND CO. INC. 8/4/2010 Page 8 of 8...