Cleaning And Maintenance - Kalorik JK 31099 Manual

Fax +32 2 359 95 50
If this happens, switch off the appliance by putting the switch in
•
OFF position and wait about 10 minutes for the element to cool.
Then pour in sufficient cold water to cover the element. This will
reset the safety device.
The kettle may then be used as normal.
•

CLEANING AND MAINTENANCE

Before attempting any cleaning operation, make sure the
•
appliance is unplugged from the supply socket and fully cooled
down.
To clean the exterior surfaces, simply wipe over with a soft damp
•
cloth and dry thoroughly.
Never use abrasive products
•
On no account shall the jug kettle or its power base be immersed
•
in water.
FILTER
Your appliance is provided with a spout filter. When you want to
•
boil water, settle the filter first. The filter needs to be in place for
the kettle to work. Removing the filter will cause dysfunction in the
auto-shut off mechanism.
When the lid is open, you can remove the particle filter by taking
•
it out of the spout and clean it under running water. Put it back
after cleaning.
Filter should be rinsed clean regularly.
•
DESCALING – REMOVING MINERAL DEPOSITS
To remove scale from the jug kettle, use products made especially
available for this purpose. Make sure to use a type recommended
for kettles or coffee makers.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
6
Assembly page 6/24
special instruction from
USK JK 31099 - 100510
Team