Inspecting Your Scan - Fuel3D SCANIFY F3D2001 User Manual

This is accomplished by pressing either one or both of the trigger buttons or by clicking the
'Capture' button in the View Finder.
Holding the scanner and using the
trigger buttons
Once a scan has been taken it will take 30 seconds for the flashes to cool down before you
can take another scan. This is shown by the progress bar at the bottom of the View Finder
image.

Inspecting your scan

Good vs bad data
When reviewing a scan you may find some bad data that you want to remove.
Rotate the scan and locate the data you wish to remove. Bad data will visibly appear
incorrect. It may appear raised, rough or overly smooth and generally will not be
comparable to the subject which was scanned.
This bad data is typically found around the edges of your scan or in areas which were not
visible when acquiring the scan.
Reflective objects, such as this spanner,
may create problems where the surface
Bad data at the edges of a scan can be
reflects the flashes
cropped out
17