Fuel3D SCANIFY F3D2001 User Manual page 10

Ideal conditions for scanning would be indoors with good lighting. If lighting is too dark you
can use the guide lights. These are on by default whilst scanning but can be toggled 'Off' or
'On' within the View Finder interface.
Ensure there are no lights in the scan capture area. Shiny objects, such as jewelry, may also
cause problems.
Capturing you scan
A scan can be captured once the scanner is in range of the target. To capture a scan you
can depress either of the triggers or click on the 'Capture' button in the view finder.
Once a scan is captured a preview will be displayed in place of the live view. You can then
select whether to save or discard the scan.
Selecting 'Save' will begin the processing of the scan and will refresh the live view. You
won't be able to view the scan until processing is complete; you can see the progress of the
processing via the timer in the lower pane, below the scan preview thumbnail.
Note:

Once a scan has been taken, it will take 30 seconds for the flashes to cool
down before you can take another scan. This is shown by the progress bar at
the bottom of the View Finder.
9
Guide light radio
button
Your scan will
begin processing