Table of Contents
Advertisement
(8)
<Changing the paper size to Letter in the metric
area>
Install the end guide plates (front and rear) at the
locations shown in the illustration.
(Two screws each)
(9) Close the tray 3.
(10) Select the LCC size setting function as follows:
System 2 → LCT (Build-in) Size Settings.
(11) Touch "Tray 3" and select the paper size that
was set for the tray 3.
(12) Touch "END."
(13) Perform the same procedure for the tray 4.
18. Configuring other options
(1) If any of the following options are installed, refer
to the "Configuration procedures" of the installa-
tion manual for each option and configure the
option(s).
• Stamp Unit SP-501
• Double feed detection Kit UK-501
• Punch Kit PK-523/PK-520
• Z Folding Unit ZU-609
• Large Capacity Unit LU-205/LU-303
• Fax Kit FK-516
• Local Interface Kit EK-611
• Security Kit SC-508
• Authentication Unit AU-201S/AU-102
• Upgrade Kit UK-212
• Hard Disk HD-524
• Working Table WT-513
• Network Fax
(2) Exit from the Service Mode and return to the ini-
tial screen.
19. Connecting the network cable
(1) Connect the main body and networking equip-
ment (HUB) using the network cable.
Note:
The following shows the recommended network
cables that correspond to each communication
speed.
• 10BaseT/100BaseTX: Category 5
• 1000BaseT: Category 5E, Category 6
LED1
LED2
Networkport
2. Check LEDs for lighting conditions.
LED1:
Should light up steadily if the link network con-
nection has been made.
LED2:
Should blink according to the communications
status of the ACT network.
E-12
Advertisement
Table of Contents
