Feature Identification - Tripp Lite PowerVerter PV1000HF Owner's Manual

Feature Identification

Identify the premium features on your specific model and quickly locate instructions on how to maximize their use.
1
Operating Mode Switch: controls Inverter operation.
Set this 3-position rocker switch to "ON" to have your
Inverter provide connected equipment with AC power
by converting DC power from an attached battery. Set
switch to "OFF" when not using connected equipment
to prevent battery drain. Set switch to "REMOTE" to
remotely monitor and control the Inverter with the use
of an optional remote module.
2
"LOAD" Indicator Lights: intuitive "traffic light"
signals show approximate equipment load level. See
page 4 for instructions on reading indicator lights.
3
"BATTERY" Indicator Lights: intuitive "traffic light"
signals show approximate charge level of your battery.
See page 4 for instructions on reading indicator lights.
4
DC Power Terminals: connect to your battery
terminals. See page 7 for connection instructions.
5
AC Receptacles: allow you to connect equipment
that would normally be plugged into a utility outlet.
PV3000HF models include two receptacles that accept
either 15- or 20-amp plugs.
6
Resettable Circuit Breaker(s): protect your Inverter
against damage due to overload. PV3000HF models
include two separate 20-amp circuits. See page 4 for
resetting instructions.
PV1000HF Front Panel
8 3 7 2 1
5 10
PV3000HF Front Panel
8
5
6
PV1000HF Rear Panel
4 9
3 7 2 1
7
Remote Control Module Connector: allows remote
monitoring and control with an optional module
(Tripp Lite model APSRM4, sold separately or included
with PV3000HF models). See remote module owner's
manual for connection instructions.
8
Battery Charge Conserver (Load Sense) Dial:
conserves battery power by setting the low-load level
at which the Inverter automatically shuts off. See page
4 for setting instructions.
9
Multi-Speed Cooling Fan(s): quiet, efficient fans
prolong equipment service life.
10
Main Ground Lug: properly grounds the Inverter to
vehicle grounding system or earth ground. See page 7
for connection instructions.
Low Battery Alarm/Shutdown (internal, not
shown): automatically detects low voltage and shuts
down Inverter to preserve vehicle battery.
Overload Alarm/Shutdown (internal, not shown):
automatically detects wattage overload on Inverter
outlets and shuts down Inverter as a protective
measure.
PV1800HF Front Panel
8 3 7
4
PV3000HF Rear Panel
5
6 10 9
4
PV1800HF Rear Panel
2 1
5 10 4
4
9 4
9