Operation - Makita DJV184 Instruction Manual

1
2
Fig.8
► 1 . Jig saw blade holder 2. Jig saw blade 3. Roller
CAUTION:
If the blade clamp lever does not
move to the fixed position, the jig saw blade is
not installed completely. Do not press the blade
clamp lever by hand to the fixed position. It may
damage the tool.
To remove the jig saw blade, push the blade clamp lever
forward as far as it will go. This allows the jig saw blade
to be released.
2
Fig.9
► 1 . Jig saw blade holder 2. Blade clamp lever 3. Jig
saw blade
NOTE: In case that it is difficult to remove the jig saw
blade:
Turn the cutting action changing lever to the position
"III" and move the jig saw blade holder to the bottom
before pushing the blade clamp lever to the released
position. To move the jig saw blade holder to the
bottom, return the blade clamp lever fully to the fixed
position once and slightly switch on the tool several
times.
NOTE: Occasionally lubricate the roller.
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Fig.10
► 1 . Hex wrench
3
1
Fig.11
3
► 1 . Cutting line 2. Base
Turn the tool on without the jig saw blade making any
contact and wait until the blade attains full speed. Then
rest the base flat on the workpiece and gently move the
tool forward along the previously marked cutting line.
10 ENGLISH
Hex wrench storage
1

OPERATION

CAUTION:
Always hold the base flush with
the workpiece. Failure to do so may cause jig saw
blade breakage, resulting in a serious injury.
CAUTION:
Advance the tool very slowly when
cutting curves or scrolling. Forcing the tool may
cause a slanted cutting surface and jig saw blade
breakage.
1
2