Advertisement
Quick Links
Product Installation Guidelines
®
CliniLever
PRODUCT CODES:
-
TCBTC80CC
-
TCBTC80HC
-
TCBTC150CC
-
TCBTC150HC
SPECIFICATIONS
−
®
The CliniLever
product range is primarily used for hand washing applications in hospitals, aged care
facilities, schools and in-home care.
−
Our highly sought after lever design is easily operated with elbows or wrist to avoid hand contact.
Quick action SBA's includes brass jumper valve / ceramic cartridge component, with red or blue indicator
−
button on 80mm or 150mm lever action handles.
−
CliniLever Top Assemblies are designed to screw directly into any 15mm body to Australian Standards
AS/NZS 3718.
IMPORTANT: All CliniLever
premises in good working order.
TECHNICAL DATA
Inlet
Outlet
Headwork
Working Pressure Range (kPa)
Working Temperature Range (°C)
Construction
Finish
NOTE: Galvin Engineering continually strive to improve their products. Specifications may change without
notice.
TOOLS REQUIRED
−
Spanner or adjustable crescent
© Galvin Engineering Pty Ltd
Basin/Sink Top Assembly
-
TCBTJ80CC
-
TCBTJ80HC
-
TCBTJ150CC
-
TCBTJ150HC
®
healthcare taps are tested in accordance with AS/NZS 3718 and leave our
Jumper Valve / Ceramic Disc
Jumper Valve / Ceramic Disc
Document No.: 001.00.10.00
Version 1, 23 November 2021, Page 1 of 5
80mm Handle - SERIES
150mm Handle - SERIES
5/8 BSP
N/A
Jumper Valve /
Ceramic Disc
Min
50
Max
500
Min
5
Max
80
Brass
Chrome
Advertisement
Related Manuals for Galvin Engineering CliniLever TCBTC80CC
Summary of Contents for Galvin Engineering CliniLever TCBTC80CC
- Page 1 Jumper Valve / Ceramic Disc Jumper Valve / Ceramic Disc Construction Brass Finish Chrome NOTE: Galvin Engineering continually strive to improve their products. Specifications may change without notice. TOOLS REQUIRED − Spanner or adjustable crescent © Galvin Engineering Pty Ltd...
-
Page 2: Pre-Installation
TCBTC150CC/TCBTC150HC/TCBTJ150CC/TCBTJ150HC INSTALLATION IMPORTANT: Galvin Engineering products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable National and/or State standards. Failing to comply with these provisions shall void the product warranty and may affect the performance of the product. - Page 3 − Once secured, connect the hot and cold water. − Open the lever handles and ensure that there is flow from both hot and cold inlets. − Inspect the tap and check for any leaks. © Galvin Engineering Pty Ltd...
-
Page 4: Service And Maintenance
Complete SBA may need to be replaced. Handle is loose Screw has come loose Tighten handle screw Flange won’t screw down onto basin/sink Tap bodies are set too far out Re-position tap bodies and breach piece surface © Galvin Engineering Pty Ltd... -
Page 5: Warranty
Version 2, 23 November 2021, 5 of The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.