Table of Contents
Advertisement
Quark-elec Manual
8.1. WiFi Ad-hoc mode
ON YOUR DEVICE (phone, laptop etc.):
About 15 seconds after the A032 has been powered up, a WiFi network with an SSID similar to 'QK-
A032xxxx' will appear in the available WiFi networks list.
Connect your device to the 'QK-A032xxxx'
WiFi network with the default password:
'88888888'.
IN THE CHART SOFTWARE:
Set the protocol to 'TCP', IP address to
'192.168.1.100' and the port number to
'2000'.
With the above settings, a wireless connection should be established, and the user should be able to
receive and view data in the chart software.
Note: In Ad-hoc mode, the IP address should not be changed.
SSID and password can be changed using the configuration software; the password should be
between 8 to 12 characters long.
Data received through the wireless connection can be monitored using TCP/IP port monitoring software
as shown below:
https://www.quark-elec.com
V4.32
Device SSID
WiFi password
Protocol
IP address
Data Port
Figure 5: TCP/IP Net Assistant
11 of 20
Similar to 'QK-A032xxxx'
88888888
TCP
192.168.1.100
2000
2021
Advertisement
Table of Contents
