Quark-elec Manual
8.1. WiFi Ad-hoc mode
ON THE DEVICE (phone, laptop etc.):
About 15 seconds after the A032 has powered up, a WiFi network with an (SSID) similar to 'QK-
A032xxxx' can be found.
Connect the device to 'QK-A032xxxx' with
the default password: '88888888'.
IN THE CHART SOFTWARE:
Set the protocol as 'TCP', IP address as
'192.168.1.100' and the port number as
'2000' in the chart software.
With the above settings, a wireless connection should be established and the user will be able to
receive the data through the chart software.
Note: In Ad-hoc mode, the IP address should not be changed.
SSID and password can be changed using the configuration software; the password should be
between 8 to 12 characters.
Users can check the wireless connection with TCP/IP port monitoring software as shown below:
https://www.quark-elec.com
V4.0
Device SSID
WiFi password
Protocol
IP address
Data Port
Figure 6: TCP/IP Net Assistant
11 of 22
Similar to 'QK-A032xxxx'
88888888
TCP
192.168.1.100
2000
2019