Table of Contents
Advertisement
Quark-elec Manual
[1]
*
Swap NMEA + and NMEA- wires if the connection does not work.
NMEA 0183
Output
NMEA 0183
Input
*
[2]
Swap NMEA input and GND / NMEA output and GND wires if the connection does not work.
6. Status LED'S
The A032 features three LEDs which indicate power, NMEA 2000 input and NMEA 0183 input status
respectively. The three LEDs turn on and then off after initialization. During normal operation, these
LEDs flash as below:
•
Power: Top LED (red) flashes at 3 second intervals.
•
NMEA 2000 INPUT：Middle LED (green) flashes for each valid NMEA 2000 PGN input.
•
NMEA 0183 INPUT：Bottom LED (green) flashes for every valid NMEA 0183 sentence input.
Please note: the NMEA LEDs flash when their respective data is received, not when data is converted
or sent.
7. Configuration
The Windows configuration tool can be used to setup the NMEA 0183 baud rate and to change WiFi
settings.
The Configuration tool can be found on the free CD or it can be downloaded from our website:
https://www.quark-elec.com/product/qk-a032-nmea-2000-0183-bi-directional-gateway/
The configuration tool instructions can be found on the free CD or it can be downloaded from our
website:
http://www.quark-elec.com/doc/QK-A0xx_GUI_application_note.pdf
https://www.quark-elec.com
V4.32
QK-A032 wire
NMEA output+
NMEA output-
NMEA input+
NMEA input-
Figure 4: LED functions
8 of 20
RS232 device terminals
GND *[2]
NMEA Input
GND *[2]
NMEA Output
2021
Advertisement
Table of Contents
