Omron H8GN Owner's Manual page 14

F
Communications
parameter setup
Note that communications parameters are enabled after they have been
changed by resetting the controller.
• Communications unit No. (
This parameter is for setting the unit No. to each of the H8GN. This unit
No. is set so that the host computer can identify the H8GN when commu
nications are carried out with the host computer. Set a unit No. within
the range 0 to 99 for each H8GN connected to the host computer on the
network. Default is 1". When two or more H8GN are used, do not set
the same unit No. Doing so will prevent normal operation.
• Baud rate (
)
This parameter is for setting the baud rate when communicating with
the host computer. Set one of 1.2 (1200 bit/s)", 2.4 (2400 bit/s)", 4.8
(4800 bit/s)" and 9.6 (9600 bit/s)".
• Communications data length (
This parameter is for setting the communications data length. Set either
of 7 bits" or 8 bits".
• Communications stop bit (
This parameter is for setting the communications stop bit. Set either of
1" or 2".
• Communications parity (
This parameter is for setting the communications parity. Set one of
none", even" or odd".
)
)
)
)
1.1 Outline
1-5