Table of Contents
Advertisement
4-2. Low Oil Sensor
To prevent engine damage caused by an
insufficient
amount
crankcase, engine is equipped with low
oil sensor. If the oil is below the safe
amount, the sensor will activate and will
prevent engine start-up or will stop the
running engine.
If pressure washer shuts off and the oil
level is within specifications, check to
see if pressure washer is sitting at an
angle that forces oil to shift.
Place on an even surface to correct this.
If engine fails to start, the oil level may
not be sufficient to deactivate low oil
level sensor. Add oil as described above.
4-3. Adding Fuel
1. Move the pressure OUTSIDE and
place on a flat and level surface.
2. Remove the gas tank cap. Carefully
add 87 Octane (or higher) grade
gasoline to the tank. DO NOT overfill.
Leave room for the gasoline to
expand.
3. Replace and hand tighten gas cap
and wipe off any spilled fuel.
Fuel and fuel vapor are extremely
flammable and explosive.
of
oil
in
the
Fire or explosion from misuse
of fuel can cause severe
burns and even death.
Failure
recommended in this manual
will void the warranty.
When adding fuel to the Pressure
Washer, observe the following:
DO NOT USE unapproved gasoline such
as E85 (85% ethanol/15%gasoline)
DO NOT mix oil with gasoline.
DO NOT modify engine to run on
alternate fuels.
Turn pressure washer OFF and let ii cool
for
at
least
two
removing fuel cap. Loosen fuel cap
slowly to release pressure.
Keep fuel away from sparks, open
flames, pilot lights, heat and other
ignition sources.
DO NOT light a cigarette or smoke near
open fuel tank or container.
Clean area around fuel fill cap and
slowly remove cap to allow any pressure
to escape. Install fuel cap and allow any
spilled fuel to evaporate before starting
engine.
DO NOT Overfill fuel tank. Slowly add
unleaded gasoline (A) to fuel tank (B).
Use extreme caution not to fill fuel
above baffle (C). This allows appropriate
space for fuel expansion.
to
use
fuel
as
minutes
before
8
Advertisement
Table of Contents
